User manual HASBRO TRANSFORMERS ROBOTS IN DISGUISE AIR ATTACK OPTIMUS PRIMAL SUPREME GORILLA

[. . . ] Pass them on to possible new owners of the appliance. The compressor and condenser give off heat and require good ventilation to operate correctly and save energy. Electrical connections After the appliance has been transported, carefully place it vertically and wait at least 3 hours before connecting it to the electricity mains. Before inserting the plug into the electrical socket ensure the following: • The appliance is earthed and the plug is compliant with the law. [. . . ] They will increase humidity in the refrigerator and cause condensation to form. Once you have bought your food, remove all external packaging made of paper/cardboard or other wrappers, which could introduce bacteria or dirt inside your refrigerator. Protect the food, (especially easily perishable items and those that have a strong smell), in order to avoid contact between them, thereby removing both the possibility of germ/bacteria contamination as well as the diffusion of strong odours inside the fridge. Store all food in such a way as to ensure air can circulate freely between different items. Keep the inside of your fridge clean, taking care not to use oxidiser or abrasive products. Remove all food past its expiry date from the refrigerator. For the correct preservation of food, all easily perishable items (soft cheeses, raw fish, meat, etc. ) should be stored in the coldest zone of the fridge compartment, i. Just above the salad crisper where the temperature indicator is situated. The SELECT button to enable the SUPER FREEZE function. After 24 hours, or once the optimal temperatures have been reached, the rapid freezing function is automatically disabled. Clean and dry the freezer compartment carefully before switching the appliance on again. Remember that the motor will not start immediately, but rather after approximately 8 minutes. Until the ideal storage conditions have been restored, before placing food in the freezer compartment. GB Cleaning the appliance • The external and internal parts, as well as the rubber seals may be cleaned using a sponge that has been soaked in lukewarm water and bicarbonate of soda or neutral soap. Avoiding mould and unpleasant odours • The appliance is manufactured with hygienic materials which are odour free. In order to maintain an odour free refrigerator and to prevent the formation of stains, food must always be covered or sealed properly. • If you want to switch the appliance off for an extended period of time, clean the inside and leave the doors open. Do not use objects with sharp or pointed edges to defrost the appliance as these may damage the refrigeration circuit beyond repair. Defrosting the refrigerator compartment The refrigerator has an automatic defrosting function: water is ducted to the back of the appliance by a special discharge outlet (see diagram) where the heat produced by the compressor causes it to evaporate. It is necessary to clean the discharge hole regularly so that the water can flow out easily. Replacing the light bulb To replace the light bulb in the refrigerator compartment, pull out the plug from the electrical socket. [. . . ] • The doors are opened too frequently. • The OPERATION knobs are not on the correct setting (see Description). • The refrigerator or the freezer have been over-filled. The food inside the refrigerator is beginning to freeze. [. . . ]