User manual HASBRO TRANSFORMERS ROBOTS IN DISGUISE SCOURGE

[. . . ] Levelling the machine correctly will provide it with stability, help to avoid vibrations and excessive noise and prevent it from shifting while it is operating. If it is placed on carpet or a rug, adjust the feet in such a way as to allow a sufficient ventilation space underneath the washer-dryer. Connecting the electricity and water supplies Connecting the water inlet hose Unpacking and levelling Unpacking 1. Remove the washer-dryer from its packaging. [. . . ] 2) Long wash cycle for cottons: set wash cycle 1 with a temperature of 40°C. 3) Short wash cycle for cottons: set wash cycle 2 with a temperature of 40°C. The information contained in the table is intended as a guide only. special wash cycles Sanitizing cycle (wash cycle 6). A high-temperature hygienic wash cycle (over 60°C) which requires the use of bleach. Pour the bleach, the detergent and the additives into the relevant compartments (see paragraph entitled “Detergent dispenser drawer”). This is a silent cycle which can be run at night, when the electricity prices are lower. The wash cycle is designed for cottons and synthetics. This wash cycle can be used to remove the soiling typically caused by babies, while ensuring that all detergent is removed from nappies in order to prevent the delicate skin of babies from suffering allergies. The cycle has been designed to reduce the amount of bacteria by using a greater quantity of water and optimising the effect of special disinfecting additives added to the detergent. At the end of the wash cycle, the machine will slowly rotate the drum to prevent the formation of creases; to end the cycle press the START/PAUSE button. load 1 , 5 kg) and guarantees optimal performance. 1 2 compartment 1: Detergent for the wash cycle (powder or liquid) Liquid detergent should only be poured in immediately prior to the start of the wash cycle. compartment 2: Additives (fabric softeners , etc. ) The fabric softener should not overflow the grid. Extra compartment 3: Bleach Load balancing system Before every spin cycle, to avoid excessive vibrations and to distribute the load in a uniform manner, the drum rotates continuously at a speed which is slightly greater than the washing rotation speed. If, after several attempts, the load is not balanced correctly, the machine spins at a reduced spin speed. If the load is excessively unbalanced, the washer-dryer performs the distribution process instead of spinning. To encourage improved load distribution and balance, we recommend small and large garments are mixed in the load. Anti-crease This function interrupts the wash programme, and the washing is left to soak in water before the appliance is drained. It can only be used with programme 9 (Silk/Curtains) and helps to prevent the formation of creases. To complete the cycle press the START/PAUSE button. [. . . ] • • • • • • • • • • The washer-dryer door is not closed properly. The START/PAUSE button has not been pressed. A delayed start has been set (using the Delay Timer, see “Personalisation”). The water inlet hose is not connected to the tap. [. . . ]