User manual HASBRO TRANSFORMES RAMPAGE DECEPTICON

[. . . ] • Never leave the packing components (plastic bags , polystyrene foam , nails , etc. ) within the reach of children since these are a source of potential danger. €¢ The appliance must be installed by a qualified technician in compliance with the instructions provided by the manufacturer. €¢ The latter denies all responsibility for improper installation which may harm persons and animals and damage property. [. . . ] Insert the hob into the cut-out slot, applying pressure all along the perimeter of the hob frame so that the latter adheres fully to the worktop. Installation • This hob can be built into a worktop simply by cutting out the corresponding slot. €¢ The worktop must be made with a material designed to withstand a temperature of approximately 100°C. €¢ The hob should be positioned at least 40 mm away from the back wall or any other vertical surface in order to allow for correct ventilation and to prevent the surfaces around the appliance from overheating. €¢ If you wish to install the hob on top of an oven, the latter must be fitted with a cooling fan. €¢ Try to avoid installing the hob on top of a dishwasher; if this is unavoidable, place a watertight separating element between the two appliances. REAR SPRING ASSEMBLY FRONT OF HOB KITCHEN WORKTOP 30 590 574 48 52 0 48 50 4 56 0+ /- 1 49 0+ /- 1 56 0+ /- 1 49 0+ /- 1 HOB FROM BELOW 690 48 520 10 56 0+ /- 1 49 0+ /- 1 Distance to keep between the cut-out slot and the cabinet 785 48 510 75 0+ /- 1 49 0+ /- 1 30 40 Technical characteristics Electrical connection • The electrical safety of this appliance can only be guaranteed if the latter is correctly and efficiently earthed, in compliance with regulations on electrical safety. Always ensure that this vital safety measure has been taken. If you have any doubts, call in a qualified technician to check the electrical system thoroughly. €¢ The manufacturer denies all responsibility for damage resulting from a system which has not been earthed correctly. €¢ Before powering the appliance, check whether the technical characteristics featured on the appliance data plate correspond with those of the mains electrical system. Timer control key for cooking time programming (only on hobs fitted with a timer) 10. Indicator light corresponding to the programmed cooking zone 12. Lock indicator light Note • The extendable zone(s) extension key (7) and the relative indicator lights (8) are only fitted on hobs featuring extendable cooking zones (concentric or oval). €¢ The timer control key (9), the cooking time indicator (10) and zone indicator lights (11) are only fitted on hobs featuring a timer. 34 Operation When you connect the hob to the power supply, a beep will sound after a few seconds: you can now turn the hob on. €¢ or press the “-” key: the heating power drops progressively until the zone eventually turns off. Turning on the hob Press key for 3 seconds to turn the hob on. Turning off the hob Press the key; the appliance has been turned off. If you have locked the hob controls (see paragraph below), the same will still be locked when you turn the hob back on. Unlock the controls in order to operate the cooking zones. Controls lock When the hob is in use, you can lock the controls to avoid any accidental changes to the settings (by children or when cleaning, for example). [. . . ] Press the key to set the zone to the maximum power setting. To go back to the smaller zone, just press the extension key again. KBT 6013 T Press key once to turn on the “medium” zone, press again. It twice to turn on the “large” zone. [. . . ]