User manual HASBRO UNITED STATESTHE GAME OF

[. . . ] Page 28 GB 21 Introduction The following pictograms are used in these operating instructions / on the device: Read instruction manual!Do not use the device on scaffolds or ladders. Never use hydrogen, oxygen, carbon dioxide or other bottled gases as an energy source. 35 mm (¼“) 5 Magazine 6 Fill level indicator 7 Knurled screw 8 Trigger lock 9 Mouth 10 Face plate 11 Face plate quick clamp lever 12 Magazine lever Observe caution and safety notes! [. . . ]  Keep your working area clean and well lit. Untidy or poorly lit working areas can lead to accidents.  Keep children and other individuals away from the fastener driving tool during use. Distractions can cause you to lose control of the device.  Remain alert at all times, watch what you are doing and always proceed with caution when working with a fastener driving tool. Do not use any fastener driving tool if you are tired or under the influence of drugs, alcohol or medication. One moment of carelessness when using the fastener driving tool may result in serious injuries. By doing this you will be in a better position to control the fastener driving tool in unforeseen circumstances.  Before any repair and maintenance work or transport, remove the device from the compressed air source. Do not use the device on scaffolds or ladders.  Never use hydrogen, oxygen, carbon dioxide or other bottled gasses to power this tool as doing so may result in an explosion and thus may cause severe injuries. Remove the protective film from the protective goggles before using for the first time. 5 onnecting C air source the compressed 3.  Slide the magazine cover forwards until it locks.  peration O NOTE: The compressed air tacker must only be operated with cleaned, oil-misted compressed air and must not exceed the maximum operating pressure of 8 bar. The compressor must be fitted with a pressure reducer in order to regulate the operating pressure.  Connect the device to a suitable compressed air source.  the magazine 5 of the compressed air Load tacker as described in the chapter “Loading the magazine“.  the pressure reducer to set the correct Use operating pressure.  nsure that the permissible operating pressure E of 8 bar at the device is never exceeded. Operating pressure that is too high does not GB 25 Operation / Maintenance and cleaning provide any performance increase, but only increases compressed air consumption and accelerates wear on the device.  the compressor to run once long enough Allow until maximum tank pressure is reached and the device is switched off. [. . . ]  the face plate 10 by pulling the face Close plate quick clamping lever 11 in the direction of the exhaust air aperture 1 .  Close the magazine 5 of the compressed air tacker as described in the chapter “Loading the magazine“.  aintenance M and cleaning  OF INJURY!Be absolutely certain to RISK disconnect the device from the compressed air source before cleaning or maintaining it. [. . . ]