User manual HASBRO WAYNE GRETZKY BRETT HULL SHOOT OUT

[. . . ] q Keep the unit away from direct sunlight, strong magnetic fields, excessive dust, humidity and electronic/electrical equipment (home computers, facsimiles, etc. ) which generates electrical noise. q Hold the AC power plug by the head when removing it from the AC socket as pulling the lead can damage internal wires. q When cleaning the heads, pinch roller, etc. , remove the AC power lead from the AC socket as the unit contains high voltages. Do not remove the outer cover, as this may result in electric shock. [. . . ] Notes: q Replace all old batteries with new ones at the same time. q Remove the batteries if they are weak or if the unit will not be used for long periods of time. This will prevent potential damage due to battery leakage. Caution: Do not use rechargeable batteries (nickel-cadmium battery, etc. ). E-3 01-E1-E9-WAYNE GRETZKY BRETT HULL SHOOT OUT(S) 4 01. 9. 19, 15:29 Sound Control Volume Turn the VOLUME control to increase or decrease the volume. Extra bass (X-BASS) Move the X-BASS control towards MAX to emphasise bass sound. Graphic equalizer Move the GRAPHIC EQUALIZER control for any frequency towards + 10 to boost the level for that frequency, and towards ­ 10 to lower the level. Surround Set the SURROUND button to ON. "Surround" refers to an acoustical effect similar to the ambience of a concert hall, where the listener has the feeling of being "surrounded" by the sound. The surround effect cannot be obtained from monaural sound signals. Listening to the Radio 1 2 3 4 Set the FUNCTION switch to RADIO. Set the BAND SELECTOR switch to FM, MW, SW1 or SW2. Turn the TUNING control to tune in to a desired station. The FINE TUNING control functions only for SW1 and SW2 bands. q The ALC (Automatic Record Level Control) circuit automatically controls the level of the input signal used for recording. q The VOLUME, X-BASS, GRAPHIC EQUALIZER and SURROUND controls may be adjusted with no effect on the recorded signal. (Variable Sound Monitor) q Metal and CrO2 tapes cannot be used for recording. s Recording from the radio s Recording from the built-in microphone 1 Set the FUNCTION switch to RADIO. 2 Set the BAND SELECTOR switch to FM, 1 Set the FUNCTION switch to TAPE. 2 Load a cassette into the cassette compartment. 3 Tune in to the station to be recorded. 4 Load a blank cassette into the cassette compartment with the side to be record- 4 Press the RECORD q button. 5 Press the PAUSE 6 button again to begin recording. q Monitoring of the recording is not possible. 7 Press the PAUSE 6 button again to be- q Recording from the built-in microphone is gin recording. To stop recording: Press the STOP/EJECT s 7 button. [. . . ] q Be sure your headphones have a 3. 5 mm (1/8") diameter plug and are between 16 ohms and 50 ohms impedance. q When headphones are connected, the speakers are disconnected automatically. Adjust the VOLUME control for desired volume. s To record on a tape 1 Load a cassette in the cassette compartment. 2 3 Press the RECORD I button. Play the CD player etc. E-8 01-E1-E9-WAYNE GRETZKY BRETT HULL SHOOT OUT(S) 9 01. 9. 19, 15:29 Maintenance s Cleaning the tape-handling s Cleaning the cabinet Periodically wipe the cabinet with a soft cloth parts q Dirty heads, capstan or pinch roller can cause poor sound and tape jams. [. . . ]