User manual HASBRO WCW NITRO HOLLYWOOD HOGAN090

[. . . ] This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Use nothing but the included cables and AC cord to insure compliance with FCC regulation for Class B computing equipment. [. . . ] INPUT 2 terminal and USB port Remove the cover to view the computer input terminal (INPUT 2) and USB port. 13) A second computer can be connected here. Security lock anchor By connecting a security lock (purchased separately) to the security lock anchor, the monitor is fixed so that it cannot be transported. The theft prevention hole works in conjunction with Kensington Micro Saver Security Systems. Connecting the monitor and turning the monitor on and off Run cord through hole. Connecting the monitor and turning the monitor on and off When connecting, ensure that both the monitor and computer are switched off. Firmly insert the analog RGB output terminal (mini D-sub 15 pin with 3 rows) then tighten the screws each side. This monitor can be used with hubs which use the USB standard (Rev. Up to 100mA of power is able to be supplied per port. Devices requiring more than 100mA cannot be connected. - Some devices may not be able to be activated. Note: - When the lock is in place, all buttons other than the power button are disabled. Choosing a message language Messages displayed on the screen and OSD Menu contents can be changed to the following languages. Use the SELECT button to choose a language. Note: - When setting up the monitor or a connected computer for the first time, connecting an additional computer or after having changed an aspect of the current system, perform an automatic screen adjustment before use Automatic adjustment screen display To perform an automatic adjustment, first display an image that makes the entire screen very bright. If you are using Windows, you can also use the Adjustment Pattern on the accompanying Monitor Settings Adjustment Disk for Windows. displaying the Adjustment Pattern (for Windows) This explanation is for Windows 95/98/2000 , and assumes that the floppy disk drive is [A drive]. Note: - If the floppy disk drive of your computer is not "A drive", please read the below substituting the floppy disk drive you are using in place of "A drive" or "A". After a few seconds the ADJUSTMENT Menu will return. Press the MENU button 4 times to make the On Screen Display (OSD) Menu disappear. Notes: - In most cases the monitor is ready to be used after automatic adjustment. - If necessary due to any of the following, manual adjustments (p. [. . . ] To activate the monitor's Power Management function, both the video card and the computer must conform to the VESA DPMS standard. You can use this function if your PC is DDC compliant and if it is set so that it can detect the Plug & Play monitor. There are many varieties of DDC due to the differences between systems. Power H-sync V-sync consumption 54W Less than 4. [. . . ]