User manual HASBRO WEEBLES HELP IN A HURRY RESCUE CENTER

[. . . ] The Declaration of Conformity can be viewed at the following URL address. Attention: If you want to dispose of this equipment, please do not use the ordinary dust bin!Used electrical and electronic equipment must be treated separately and in accordance with legislation that requires proper treatment, recovery and recycling of used electrical and electronic equipment. Following the implementation by member states, private households within the EU states may return their used electrical and electronic equipment to designated collection facilities free of charge*. [. . . ] When sending to multiple locations, only auto-dial numbers can be used to Press (or ) until the name of the number appears in the display (if no name was stored, the number will appear). Repeat Steps 3 and 4 for each of the other locations to which you wish to send the fax (maximum of 20). When you are ready to begin transmission, press Check the "Note" column of the report to see if any of the locations are marked "Busy" or have a communication error code. You can also send a fax through memory when sending to a single location. This is convenient when sending to locations where the line is often busy, as it saves you from waiting to pick up the original document and frees the feeder for other operations. To send a fax through memory, load the document, press then dial using one of the following methods: Press the number keys to enter the fax number and press Press Once to select the last number dialled and press If the memory becomes full while the document is being scanned, MEMORY IS FULL and SEE MANUAL will alternately appear in the display. If you want to transmit the pages which have been After transmission, the memory will be cleared and you can transmit the remaining pages. You will also need to transmit the page which was being scanned when the memory filled up. If you want to cancel the entire transmission. When the reception mode is set to TEL/FAX, your fax machine automatically answers all calls on two rings. After answering, your fax monitors the line for about five seconds to see if a fax tone is being sent. Your fax will automatically begin reception if you hear a soft fax tone after answering a call on your fax or an extension phone. If you use a computer fax modem to send documents on the same line, you must turn this function off in order to prevent your fax from mistakenly attempting to receive documents from the computer fax modem. Follow the steps below to change the setting. If desired, you can use a number other than 5 to activate fax reception from an extension telephone. Enter the desired number (any number from 0 to 9). The fax has been set at the factory to automatically reduce the size of received documents to fit the size of the printing paper. This ensures that data on the edges of the document are not cut off. If desired, you can turn this function off and have received documents printed at full size. If a document is too long to fit on the printing paper, the remainder will be printed on a second page. In this case, the cut-off point may occur in the middle of a line. Automatic reduction may not be possible if the received document is too Large, contains too many fine graphics or images, or is sent at high resolution. [. . . ] This appears if you attempt to search for an auto-dial number when none have been stored. This appears if you forgot to replace the handset after using it to dial and send a fax. Replace the handset or press the STOP key to clear the message. ON HOOK DIAL The key has been pressed and the fax machine is waiting for you to dial. [. . . ]