User manual HASBRO XEVOZ ALPHA RANGER NEO SAPIENS

[. . . ] This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Use nothing but the included cables and AC cord to insure compliance with FCC regulation for Class B computing equipment. [. . . ] 19) Note: - All adjustments will be saved even after turning the power off. Setting the lock) any attempted changes to adjusted values will be voided. While pressing the MENU button, press the power button (i. continue to press the button until the message appears on the screen. When the menu is unlocked: [ADJUSTMENT LOCKED] will appear on the screen, and the lock will be set. When the menu is locked: [ADJUSTMENT UNLOCKED] will appear on the screen, and the lock will be removed. This chapter provides the procedure how to adjust the screen by using Adjustment Pattern (for Windows) MANUAL: Individual menu options are manually adjusted. - To choose a menu option:SELECT button - To go to the next menu: MENU button CLOCK The figure below demonstrates how to adjust so that buttons) vertical flicker noise is not emitted. At this point relevant menu options can be adjusted. Each time the MENU button is pressed the next menu is selected. (ADJUSTMENT GAIN CONTROL WHITE BALANCE MODE SELECT OSD Menu disappears) Notes: - The OSD Menu automatically disappears several seconds after the last command. If you are using Windows, open the Test Pattern on the accompanying Utility Disk. 15) If your system is not Windows, you can not use the Adjustment Pattern. Therefore display an image that makes the entire screen light and adjust it through checking visually its actual tone. At this point relevant menu options can be adjusted. Each time the MENU button is pressed the next menu is selected. (WHITE BALANCE MODE SELECT OSD Menu disappears) Notes: - The OSD Menu automatically disappears several seconds after the last command. Notes: - On settings other than [STD] not all graduations can be displayed. - Selecting USER will display the setting values for [R-CONTRAST], [G-CONTRAST] and [B-CONTRAST], in order to make fine adjustments. Button for yellow button for blue Notes: - Depending on the resolution of the input signal, even if menu options can be selected, the display may not change. - To choose a menu option: SELECT button - When adjustment complete: MENU button OSD H-POSITION (OSD horizontal position) The position of the OSD display can be moved to the buttons) left and right. ( OSD V-POSITION (OSD vertical position) The position of the OSD display can be moved up buttons) and down. [. . . ] Klicken Sie auf [Display a list of all the drivers in a specific location, so you can select the driver you want. Aktivieren Sie [Display a list of the known drivers for this device so that I can choose a specific driver], und klicken Sie auf [Next]. Aktivieren Sie [Display a list of all the drivers in a specific location, so you can select the driver you want. Aktivieren Sie [Display a list of all the drivers in a specific location, so you can select the driver you want. [. . . ]