User manual HASBRO YAHTZEE DELUXE EDITION 2004 SPANISH

[. . . ] NÄR DENNA DEL ÄR ÖPPNAD OCH UND VORSICHT UNSICHTBARE LASERSTRAHLUNG WENN ABDECKUNG GEÖFFNETAUSSETZEN. VARNING OSYNLIG LASERSTRÅLNING FARLIG. STRÅLEN ÄR SICHERHEITSVERRIEGELUNG ÜBERERÜCKT. NICHT DEM STRAHL AVATTAESSA JA SUOJALUKITUS OHITETTAESSA OLET ALTTIINA NÄKYMÄTÖNTÄ USYNLIG LASERSTRÅLING VED ÅBNING, NÅR SIKKERHEDSAFBRYDERE ER ADVARSEL UDE AF FUNKTION. [. . . ] ON 600dpi * Factory default settings are indicated with an asterisk (*). 5 Press the start ( ) key. The right-hand number in the display will be steadily lit and the entered value will be stored. To change the setting or to set another mode, press the clear ( ) key. The unit will return to step 2. 6 Press the light ( copy mode. ) or dark ( ) key to return to the normal DISPLAYING TOTAL NUMBER OF COPIES Use the following procedure to display the total number of copies. Press and hold down the clear ( ) key for approximately 5 seconds. The total number of copies will appear in two steps, each with three digits. Example: Total number of copies is 1, 234. 20 5 MAINTENANCE Be sure to use only genuine HASBRO parts and supplies. This chapter describes how to replace the toner cartridge and how to clean unit. For best copying results, be sure to use only HASBRO Genuine Supplies which are designed, engineered, and tested to maximise the life and performance of HASBRO copiers. Look for the Genuine Supplies label on the toner package. TONER CARTRIDGE REPLACEMENT When the toner cartridge replacement required ( ) indicator lights up, replacement of the toner cartridge will be needed soon. When the toner cartridge replacement required ( ) indicator blinks, the toner cartridge must be replaced before copying can be resumed. Replace the toner cartridge by following the procedure below. During long copy run of a dark original, the start ( ) indicator may blink, the indicator light up, and the unit stop, even though toner is left. The unit will feed toner up to 2 minutes and then the start ( ) indicator will light up. Press the start ( ) key to restart copying. 5 1 Open the side cover while pressing the side cover open button. 2 Push gently on both sides of the front cover to open the cover. 21 3 Gently pull the toner cartridge out while pressing the lock release lever. Toner cartridge lock release lever · After removing the toner cartridge, do not shake it or tap on it. (p. 13) Open the side cover while pressing the side cover open button. Take the charger cleaner out by holding the tab. Set the charger cleaner onto the right end of the transfer charger, gently slide the cleaner to the left end, and then remove it. Repeat this operation two or three times. Slide the charger cleaner from the right end to the left end along the groove of the transfer charger. If the cleaner is stopped on the way, smudges on copies may occur. 5 4 Return the charger cleaner to its original position. Close the side cover by pressing the round projections near the side cover open button. 5 Turn the power switch on. (p. 12) 25 6 TROUBLESHOOTING THE UNIT This chapter describes misfeed removal and troubleshooting. TROUBLESHOOTING If any problem occurs, check the list below before contacting your authorised service representative. Solution Page Plug the unit into a grounded outlet. 12 Unit does not Gently close the side cover. Gently close the front cover and then 23 close the side cover. Is the original placed face Place the original face down on the Blank copies 14 down on the original table?Is original image too dark or Adjust the exposure manually. [. . . ] 24 - Original cover . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 24 - Original table . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 24 - Transfer changer . . . . . . . . . . . . . . . . . . . . . . . . . . 25 Copying . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]