User manual HASBRO YAHTZEE ELECTRONIC 1999

[. . . ] 29 · When User Authentication is not Enabled . 29 · When User Authentication is Enabled . 30 System Settings (Administrator) List . 46 · User Authentication Setting . [. . . ] Select the number of the key that you want to configure, referring to "Screen Key Layout". The name of the key selected in "Key Number" can be changed (maximum of 48 characters). Specify the function that you want to use in the key selected in "Key Number". Description * Does not appear when user authentication is not enabled. This setting can only be configured in the Web pages. It cannot be configured in the touch panel of the machine. Display Pattern Setting One of six colour patterns can be selected for the colour pattern in the touch panel. A sample of the selected pattern can be viewed. 60 Device Control These settings control devices installed on the machine. Touch the [Device Control] key to configure the settings. Other Settings Original Feeding Mode The following original feeding modes can be set to operate by default in copy, Scan to HDD, and image send modes. When a mode is frequently used, this saves you from having to select the mode in the special modes each time you need to use it. · Mixed Size Original (Same Width/Different Width) · Slow Scan Mode Tandem Connection Setting When two machines are used as network printers using TCP/IP protocol, use this setting to configure the port number and IP address of the machine used as the tandem slave machine. Disabling of Master Machine Mode To prohibit tandem transmission, enable this setting. (There is normally no need to enable this setting. ) Disabling of Slave Machine Mode To prohibit tandem reception, enable this setting. (There is normally no need to enable this setting. ) · The factory default setting for the port number is [50001]. Once this setting is enabled, only a service technician can cancel the setting. Promptly contact your dealer or nearest authorised service representative to have a service technician cancel the setting and resolve the colour-related problem. Disabling of Finisher (When a saddle stitch finisher or finisher is installed. ) This setting is used to disable the saddle stitch finisher or finisher, such as when the unit malfunctions. Disabling of Inserter (When an inserter is installed. ) This setting is used to prohibit the use of the inserter, such as when it malfunctions. Fusing Control Settings This is used to set the weight of paper from 60 to 105 g/m2 (16 to 28 lbs. ) for control of fusing temperature by paper weight. To make this setting take effect, press the [POWER] key ( [POWER] key ( ) again to turn the power on. ) to turn the power off, wait briefly, and then press the 64 Copy Function Settings The following settings are related to copying. Touch the [Copy Function Settings] key to configure the settings. Default settings selected with these settings apply to all functions of the machine (not just the copy function). Initial Status Settings The copier settings are reset when the [POWER] key ( ) is turned on, when the [CLEAR ALL] key ( ) is pressed, or when the auto clear interval has elapsed. These settings are used to change the default settings for copy mode. The following settings can be changed: Item Colour Mode Paper Tray Exposure Type Copy Ratio Configure default colour mode settings. Specify the paper tray that is selected by default. Specify the copy ratio that is selected by default. Configure the 2-sided mode settings that are selected by default. If this setting is used to change the default setting for the duplex function to other than "1-Side to 1-Side" and the duplex function or automatic document feeder fails or is disabled, the setting will revert to "1-Side to 1-Side". [. . . ] Print Actual Size Cut off Disabled The received fax image is printed at full size without dividing it onto multiple sheets of paper. If the same size of paper or larger paper is not loaded, the fax will be received in memory and will not be printed until a suitable size of paper is loaded. However, if the received fax is longer than A3 (11" x 17") size, it will be automatically divided onto multiple sheets of paper. Print Actual Size Cut off Enabled Each received image is printed at full size. [. . . ]