User manual HASBRO ZIP UNCLE REMUS GAME098

[. . . ] Setting up a Network Connection for the Monitor . . . . 14 Subnet Mask Setting ([2]Subnet Mask) . . . . . . . . . . . . . . . 26 Default Gateway Setting ([3]Default Gateway) . . . . 26 User Name Setting ([4]User Name) . . . . . . . . . . . . . . . . . . . . . [. . . ] Setting the time interval in which the monitor will be automatically disconnected from the network in units of a minute (from 1 to 65535 minutes). If the set value is made 0, the Auto Logout function is disabled. Setting the TCP port number used when exchanging data with the monitor (from 1025 to 65535). Setting the port number used when searching for the monitor (from 1025 to 65535). On this screen, you can make settings for sending e-mail to report when the monitor has generated an error. Items SMTP Server Setting example / Remarks Setting an SMTP server address for e-mail transmission. e. g. 1 : 192. 168. 150. 253 e. g. 2 : smtp123. sharp. co. jp * When using a domain name, make settings for the DNS server. Setting the monitor's e-mail address. The e-mail address set here becomes Originator E-mail Address. The name set here appears in the "Originator Name" column of the body of the message. Data Port Originator E-mail Address Originator Name Search Port After clicking the "Apply" button, the set values appear. Confirm that the values are set properly, and then click the "Confirm" button. Note · SMTP Server, Originator E-mail Address and Originator Name can be up to 64 characters. · You can input the characters below: SMTP Server and Originator E-mail Address : a-z, A-Z, 0-9, !, #, $, %, &, *, +, -, /, =, ?, ^, {, |, }, ~, _, ', . , @, ` (You can input "@" only one time for "Originator E-mail Address". ) Originator Name : a-z, A-Z, 0-9, -, _, (, ), space · If the settings of "3. Setting up a Network Connection for the Monitor" on pages 14 and 15 are incorrectly set, e-mail will not be send. Note · After setting items, wait for 10 seconds and then re-access. (Page 26) [5]Password (Factory default setting : Not Required) Setting of password for security protection. (Page 27) [6]RS-232C Baud Rate (Factory default setting : 9600 bps) Baud rate settings for the RS-232C terminals. (Page 27) [7]Monitor Name It is possible to assign a monitor name. (Page 27) [8]DHCP Client DHCP Client settings. (Page 27) [A]Advanced Setup Enters ADVANCED SETUP MENU. (Page 28) [D]Disconnect All Disconnect all connections. (Page 28) [V] View All Setting Displays all setting values. (Page 24) Can also be used with ADVANCED SETUP MENU. [S] Save & Quit Save set values and quit menu. (Page 25) [Q]Quit Unchanged Quit menu without saving setting values. (Page 25) advanced> [1]Auto Logout Time (Factory default setting : 5 minutes) Setting of time until automatic disconnection of network connection. [. . . ] \ Check that the LAN cable is a cross-over cable when connecting the monitor to a computer directly. \ Check that the LAN cable is a straight-through cable when connecting the monitor with a network device such as a hub. \ Check that the power supply is turned on for the network device such as a hub between the monitor and a computer. Check the network settings for the computer and the monitor \ Check the following network settings for the monitor. · IP Address Check that the IP address for the monitor is not duplicated on the network. [. . . ]