User manual HASBRO ZOIDS PTERAMANDER

[. . . ] NÄR DENNA DEL ÄR ÖPPNAD OCH UND VORSICHT UNSICHTBARE LASERSTRAHLUNG WENN ABDECKUNG GEÖFFNETAUSSETZEN. VARNING OSYNLIG LASERSTRÅLNING FARLIG. STRÅLEN ÄR SICHERHEITSVERRIEGELUNG ÜBERERÜCKT. NICHT DEM STRAHL AVATTAESSA JA SUOJALUKITUS OHITETTAESSA OLET ALTTIINA NÄKYMÄTÖNTÄ USYNLIG LASERSTRÅLING VED ÅBNING, NÅR SIKKERHEDSAFBRYDERE ER ADVARSEL UDE AF FUNKTION. [. . . ] See "SET THE COPY QUANTITY" (p. 49), "EXPOSURE ADJUSTMENT/PHOTO COPYING" (p. 49), and "REDUCTION/ENLARGEMENT/ZOOM" (p. 51). Using the original table If you are using the original table, copying is only possible in one sided to two-sided mode ("A" above). The original is scanned into the unit's memory. 2 Place the original that you wish to copy onto the rear side of the paper, and press the start ( ) key again. Using the SPF/RSPF Press the start ( ) key. Copying begins in the selected two-sided copy mode. 6 53 3 4 DESCRIPTION OF SPECIAL FUNCTIONS Toner save mode (page 54) Reduces toner consumption by approximately 10%. Power save modes (page 55) The unit has two power save modes of operation: preheat mode and auto power shut-off mode. Preheat mode When the unit enters the preheat mode, the power save ( ) indicator will light up and other indicators will remain on or off as before. In this condition, the fuser in the unit is maintained at a lower heat level, thereby saving power. To copy from the preheat mode, make desired copier selections and press the start ( ) key using the normal copying procedure. Auto power shut-off mode When the unit enters the auto power shut-off mode, the power save ( ) indicator will light up and other indicators will go out. The auto power shut-off mode saves more power than the preheat mode but requires a longer time before starting copying. To copy from the auto power shut-off mode, press the start ( ) key. Then make desired copier selections and press the start ( ) key using the normal copying procedure. Auto clear (page 55) The unit returns to the initial settings a preset amount of time after the end of copy, or scanner operation. This preset amount of time (auto clear time) can be changed. Stream feeding mode (page 55) For description of the stream feeding mode, see "Stream feeding mode" (p. 49). Resolution of AUTO & MANUAL mode (page 55) You can set the copy resolution used for AUTO and MANUAL ( mode. For more information on purchasing the TD cartridge, see "ABOUT SUPPLIES AND OPTIONS" (p. 70). If copying is continued while the indicator is lit, copies will gradually become lighter until the unit stops and the indicator begins blinking. Replace the old TD cartridge by following the procedure below. · After the unit stops, it may be possible to make a few more copies by taking the TD cartridge out of the unit, shaking it horizontally, then reinstalling it. If copying is not possible after this operation, replace the TD cartridge. · During long copy run of a dark original, the start ( ) indicator may blink, the indicator light up, and the unit stop, even though toner is left. The unit will feed toner up to 2 minutes and then the start ( ) indicator will light up. Press the start ( ) key to restart copying. 1 Open the multi-bypass tray (ZOIDS PTERAMANDER, AL-1555), side cover, and front cover, in that order. To open the multi-bypass tray, see "The multi-bypass tray (ZOIDS PTERAMANDER, AL1555)" (p. 17). To open the side cover and front cover, see "INSTALLING THE TD CARTRIDGE" (p. 10). 2 Gently pull the TD cartridge out while pressing the lock release button. Lock release button 7 Dispose of the old TD cartridge in accordance with local regulations. 3 Install a new TD cartridge. To install the new cartridge, see "INSTALLING THE TD CARTRIDGE" (p. 10). 57 4 Close the front cover and then the side cover by pressing the round projections near the side cover open button. The indicator ( ) will go out and the start ( ) indicator will light up. When closing the covers, be sure to close the front cover securely and then close the side cover. [. . . ] However, all materials may present unknown hazards and should be used with caution. Although certain hazards are described herein, we do not guarantee that these are the only hazards which exist. A. Information on Disposal for Users (private households) 1. In the European Union Attention: If you want to dispose of this equipment, please do not use the ordinary dust bin! [. . . ]