User manual HASE BARI

[. . . ] Provides additional tips about using the stove as well as useful information. Sections marked with this symbol provide information about safe and environmentallyfriendly operation as well as environmental laws and regulations. With regard to flammable materials beyond the heat radiating area, a safety distance of 20 cm at the sides of the stove and 20 cm behind the stove has to be adhered to (Fig. , wood, laminate, carpeting, ) must be protected with a floorplate made of non-combustible material (e. [. . . ] Just lift the handle (a) to release the latch and then rotate the Bari to the desired position. (Not applicable if Hase ventilation system is used. ) When installing the Bari, ensure that the score (b) faces towards the front (Fig. The surface of your stove was treated in a sandblasting machine before applying the colour coating. Despite careful and thorough inspection, there may still be some residual material in the stove body, which can fall out when your stove is being installed. To prevent any damage, please immediately vacuum up these small steel pellets with a vacuum cleaner. The first time a stove is operated, the heat development causes the emission of volatile components from the coating, sealing strips and lubricants, and smoke and odours can occur. At a higher combustion temperature, this one-time process can take between 4 to 5 hours. To achieve this higher combustion temperature, please increase the fuel quantity recommended in Section 7, , , Adding Fuel/ Heating with Nominal Thermal Output", by approximately 25%. To prevent adverse effects on health, nobody should stay in the room(s) during this process Always comply with the safety distances to combustible and flammable materials!Make sure the room is well-ventilated and open the windows and outside doors. If needed, use a fan for faster air circulation. If the maximum temperature is not reached during the first heating operation, you may notice an odour for a short period of time the next time the stove is used as well. More fuel should be added to the fire when the flames from the previous burning off phase have just gone out. Move primary air slider (I) to position 1 from left. The firing up phase should be as short as possible, since higher emissions can occur during this phase. The slider settings described in Table 1 (see figure on the right) are recommendations that were determined under conformance testing conditions, in compliance with the relevant standard. Depending on the weather conditions and the draught capability of your chimney, accordingly adjust the slider positions for your Bari to the local conditions. The Bari may only be operated when the fire box door is closed; the fire box door may only be opened to add fuel. Open fire grate Pile up any remaining ash and unburned Charcoal into the centre of the combustion chamber. [. . . ] Slide the lid onto the ash drawer so that it is closed; this prevents ashes from flying around, which in turn means your home stays clean. Piled up ashes can impair or even block the supply of primary air supply to the stove. Please ensure that the air supply path for the primary air between the ash drawer and the bottom of the ash compartment remains clear. Wood should be used for the warming-up phase and when adding fuel for the first time, see "Warming-up Phase". [. . . ]