User manual HASE JENA

[. . . ] This section contains important information on using this technical documentation. Utmost care was taken in preparing this document. Nevertheless, suggestions for improvement and comments regarding any errors are always welcome. This symbol alerts you to a potentially hazardous situation. [. . . ] 5 kg and are no longer than 25 cm in length for about 45 min. 6 kg and are no longer than 25 cm in length for about 40 min. During shipment, condensation moisture can accumulate in the stove's interior, which may possibly lead to the appearance of condensation or water on the stove or flue pipes. To prevent adverse effects on health, nobody should stay in the room(s) during this process unless absolutely necessary. Make sure the room is well-ventilated and open the windows and outside doors. If needed, use a fan for faster air circulation. If the maximum temperature is not reached during the first heating operation, you may notice an odour for a short period of time the next time the stove is used as well. Pile up any remaining ash and unburned Charcoal into the centre of the combustion chamber. Place 2-3 small logs into the middle of the fire box; stack approx. Light the ignition material at several places. Pull primary and secondary air slider all the way out. The surface of your stove was treated in a sandblasting machine before applying the colour coating. Despite careful and thorough inspection, there may still be some residual material in the stove body, which can fall out when your stove is being installed. To prevent any damage, please immediately vacuum up these small steel pellets with a vacuum cleaner. The first time a stove is operated, the heat development causes the emission of volatile components from the coating, sealing strips and lubricants, and smoke and odours can occur. At a higher combustion temperature, this one-time process can take between 4 to 5 hours. To achieve this higher combustion temperature, please increase the fuel quantity recommended in Section 7, , , Adding Fuel/ Heating with Nominal Thermal Output", by approximately 25%. The firing up phase should be as short as possible, since higher emissions can occur during this phase. The slider settings described in Table 1 (see figure on the right) are recommendations that were determined under conformance testing conditions, in compliance with the relevant standard. Depending on the weather conditions and the draught capability of your chimney, accordingly adjust the slider positions for your Jena to the local conditions. [. . . ] Piled up ashes can impair or even block the supply of primary air supply to the stove. Please ensure that the air supply path for the primary air between the ash drawer and the bottom of the ash compartment remains clear. 15 a B-VG (Austria), can only be operated when the fire box is closed; more than one device can be connected to the chimney. Depending on the insulation of the building, the nominal thermal output of 6 kW indicated on 20 - 80 m² (subject to change) Dimensions: Stove Fire box Height 115, 5 cm 38 cm Steel 195 kg with ceramic 206 kg with soapstone Width 54 cm 28 cm Ceramic 204 kg Depth 49 cm 31, 5 cm Soapstone 248 kg The following data applies to the chimney characteristics in accordance with EN 13384-1 / 2 The original Declaration of Conformity and associated documents are available from the manufacturer upon request. [. . . ]