User manual HASE LIMA

[. . . ] Provides additional tips about using the stove as well as useful information. Sections marked with this symbol provide information about safe and environmentallyfriendly operation as well as environmental laws and regulations. Within a radius of 80 cm in front of and 40 cm around the stove, flammable, combustible, or heat-sensitive materials (e. [. . . ] Use the same procedure to set the range of rotation for the left side. Always comply with the safety distances to combustible and flammable materials!If a floor plate is required, its size must match the rotating range of the stove. During shipment, condensation moisture can accumulate in the stove's interior, which may possibly lead to the appearance of condensation or water on the stove or flue pipes. Make sure the room is well-ventilated and open the windows and outside doors. If needed, use a fan for faster air circulation. If the maximum temperature is not reached during the first heating operation, you may notice an odour for a short period of time the next time the stove is used as well. Open fire grate Pile up any remaining ash and unburned Charcoal into the centre of the combustion chamber. Place 2-3 small logs into the middle of the fire box; stack approx. Light the ignition material at several places. Pull secondary air slider all the way out Pull out fire grate slider The surface of your stove was treated in a sandblasting machine before applying the colour coating. Despite careful and thorough inspection, there may still be some residual material in the stove body, which can fall out when your stove is being installed. To prevent any damage, please immediately vacuum up these small steel pellets with a vacuum cleaner. The first time a stove is operated, the heat development causes the emission of volatile components from the coating, sealing strips and lubricants, and smoke and odours can occur. At a higher combustion temperature, this one-time process can take between 4 to 5 hours. To achieve this higher combustion temperature, please increase the fuel quantity recommended in Section 8, , , Adding Fuel/ Heating with Nominal Thermal Output", by approximately 25%. To prevent adverse effects on health, nobody should stay in the room(s) during this process The firing up phase should be as short as possible, since higher emissions can occur during this phase. The slider settings described in Table 1 (see figure on the right) are recommendations that were determined under conformance testing conditions, in compliance with the relevant standard. [. . . ] Please ensure that the air supply path for the primary air between the ash drawer and the bottom of the ash compartment remains clear. More fuel should be added to the fire when the flames from the previous burning off phase have just gone out. Place logs with one end to the front of fire box. [. . . ]