User manual HASE LUNO

[. . . ] Dear Hase customer, In deciding on a Hase stove, you have purchased a top quality product. It goes without saying that we only use first-rate materials and process them with superior craftsmanship and the greatest care and precision. At our headquarters in Trier, Germany, we put our love of detail into every stove we develop and manufacture, thus ensuring that they meet the highest standards in design, functionality, and eco-friendliness. The well-balanced design, state-of-the-art production processes, as well as our efficient and environmentally-friendly combustion technology will let you keep enjoying your Hase stove for years to come. [. . . ] 1 Primary Air The primary air is guided through the grate and into the fire box from below, which allows the stove to reach the required fire box temperature more quickly during the warming up phase. 0 kg and are no longer than 30 cm in length for about 50 min. 5 kW, burn wood logs that weigh 1 kg and are no longer than 25 cm in length for about 45 min. During shipment, condensation moisture can accumulate in the stove's interior, which may possibly lead to the appearance of condensation or water on the stove or flue pipes. please dry off these damp areas imme diately. The surface of your stove was treated in a sandblasting machine before applying the colour coating. Despite careful and thorough inspection, there may still be some residual material in the stove body, which can fall out when your stove is being installed. To prevent any damage, please immediately vacuum up these small steel pellets with a vacuum cleaner. The first time a stove is operated, the heat development causes the emission of volatile components from the coating, sealing strips and lubricants, and smoke and odours can occur. At a higher combustion temperature, this one-time process can take between 4 to 5 hours. To achieve this higher combustion temperature, please increase the fuel quantity recommended in Section 14, , , Adding Fuel/ Heating with Nominal Thermal Output", by approximately 25%. To prevent adverse effects on health, nobody should stay in the room(s) during this process unless absolutely necessary. Make sure the room is well-ventilated and open the windows and outside doors. If needed, use a fan for faster air circulation. If the maximum temperature is not reached during the first heating operation, you may notice an odour for a short period of time the next time the stove is used as well. Lighting the Fire The firing up phase should be as short as possible, since higher emissions can occur during this phase. The slider settings described in Table 1 (see figure on the right) are recommendations that were determined under conformance testing conditions, in compliance with the relevant standard. Depending on the weather conditions and the draught capability of your chimney, accordingly adjust the slider positions for your Luno to the local conditions. While the ash collects during the fire, the lid is located under the ash drawer. remove both the ash drawer and the lid located underneath it. Slide the lid onto the ash drawer so that it is closed; this prevents ashes from flying around, which in turn means your home stays clean. 2 Degasification Phase At temperatures between 100°C and 150°C, the contents of the wood start - slowly at first ­ to disintegrate and gasify and the wood begins its thermal decomposition. [. . . ] Tears or cracks in the heat-resisting slabs do not impair the functioning of your stove. To prevent damaging the heat-resisting slabs, place logs carefully in the fire box and do not let them fall against the walls of the fire box. The sealing strips are wearing parts and thus have to be replaced in line with the frequency of use. Possible Problem The wood does not light or lights only slowly. [. . . ]