User manual HASE VALENCIA

[. . . ] This section contains important information on using this technical documentation. Utmost care was taken in preparing this document. Nevertheless, suggestions for improvement and comments regarding any errors are always welcome. [. . . ] , wood, laminate, carpeting, ) must be protected with a floorplate made of non-combustible material (e. The size of the floorplate must be larger than the base of the stove by at least 50 cm in front and at least 11 cm at the sides of the stove (Fig. The thermal output depends on the amount of fuel you put in the stove. When adding more fuel, please do not exceed the maximum fuel load size of 2. Exceeding the maximum fuel load size leads to a danger of overheating, which can result in damage to the stove and the risk of a stove fire. 9 kg and are no longer than 33 cm in length for about 45 min. 7 kg and are no longer than 25 cm in length for about 35 min. During shipment, condensation moisture can accumulate in the stove's interior, which may possibly lead to the appearance of condensation or water on the stove or flue pipes. Make sure the room is well-ventilated and open the windows and outside doors. If needed, use a fan for faster air circulation. If the maximum temperature is not reached during the first heating operation, you may notice an odour for a short period of time the next time the stove is used as well. The surface of your stove was treated in a sandblasting machine before applying the colour coating. Despite careful and thorough inspection, there may still be some residual material in the stove body, which can fall out when your stove is being installed. To prevent any damage, please immediately vacuum up these small steel pellets with a vacuum cleaner. The first time a stove is operated, the heat development causes the emission of volatile components from the coating, sealing strips and lubricants, and smoke and odours can occur. At a higher combustion temperature, this one-time process can take between 4 to 5 hours. To achieve this higher combustion temperature, please increase the fuel quantity recommended in Section 7, , , Adding Fuel/ Heating with Nominal Thermal Output", by approximately 25%. To prevent adverse effects on health, nobody should stay in the room(s) during this process The firing up phase should be as short as possible, since higher emissions can occur during this phase. [. . . ] Place logs with the end to the front of fire box. 15 a B-VG (Austria), can only be operated when the fire box is closed; more than one device can be connected to the chimney. (A): FSPS-Wa 1853 -A The following data applies to the chimney characteristics in accordance with EN 13384-1 / 2: Combustion Values Depending on the insulation of the building, the nominal thermal output of 8 kW indicated on 30 - 115 m² (subject to change) Dimensions: Stove Fire box Height 200, 5 cm - variable 51, 5 cm Ceramic Weight: 343 kg Soapstone 386 kg Width 86 cm 31, 5 cm The original Declaration of Conformity and associated documents are available from the manufacturer upon request. [. . . ]