User manual HATCO GR2AM-0601

[. . . ] GLO-RAY ® Designer Infrared Foodwarmers GR2A & GR2AH Series Installation & Operating Manual I&W # 07. 05. 115. 00 This manual contains important safety information concerning the maintenance, use and operation of this product. Failure to follow the instructions contained in this manual may result in serious injury. If you are unable to understand the contents of this manual, please bring it to the attention of your supervisor. Do not operate this equipment unless you have read and understood the contents of this manual. Este manual contiene importante información sobre seguridad concerniente al mantenimiento, uso y operación de este producto. [. . . ] Contact the manufacturer of the base material for application information. 10-14" (25- 36 cm) Standard Watt 14-18" (36-46 cm) High Watt 18"-21" (46-53 cm) 12"-14" (30-36 cm) 14"-16" (36-41 cm) 18" or 24" (46-61 cm) Figure 3. GR2AM-0601 12 11-14" (28- 36 cm) High Watt 9" (23 cm) 8-12" (20- 30 cm) Standard Watt 9" (23 cm) INSTALLATION ALL MODELS Glo-Ray Designer Infrared Foodwarmers are shipped with most components pre-assembled. Optional non-adjustable tubular stands (10", 12" and 16") are available from the factory. Optional breath protectors must be installed on location. Care should be taken when unpacking shipping carton to avoid damage to unit and components enclosed. 15" 6" 3" 6" Dual With 3" Spacer 18" ASSEMBLY NOTE: It is recommended that at least two people assist in the assembly/installation of the unit. Longer units may require 3 or more people. Remove the unit from the carton and lay it upside down on the cardboard. Remove the extension cover from the tubular stand. It may be necessary to use a rubber mallet. Place the stand onto the unit with the exposed channel facing outward. Align mounting holes on tubular stand with mounting holes on bracket. Attach angle bracket and stand to mounting bracket with mounting bolts provided. Remove screw from warmer and attach the angle bracket to the warmer using the screw. Repeat steps 2 - 4 for other tubular stand. While holding unit in place, use the flange mounting holes as a template and mark the holes on the mounting surface. Remove the unit and drill the mounting holes. Place the warmer into position over the mounting holes with the electrical conduit positioned through the channel and center mounting hole. Secure the unit to the mounting surface with 1/4 x 1-1/2" hex bolts and nuts provided. NOTE: If installing single models side-by-side, a minimum distance of 3" (7. 6 cm) must be maintained between warmers. Reinstall covers to stands by snapping into place. Figure 6. Installing Unit 6" 6" 6" Dual With 6" Spacer Figure 4. Assembling Tubular Stand To Unit NOTE: GR2A series units mounted to a metal surface may require a backing plate installed to the underside of the surface in order to increase unit stability. [. . . ] Oklahoma City 405-528-8883 OREGON Bressie Electric Co. Portland 503-231-7171 503-624-0890 PENNSYLVANIA Authorized Factory Service Coraopolis 412-262-2330 FAST Comm. Service Philadelphia 215-288-4800 GCS Service, Inc. Pittsburgh 412-787-1970 K & D Service Co. [. . . ]