User manual HATCO GR2S-2BWM-0203

[. . . ] GLO-RAY® Designer Heated Shelf & Buffet Warmer GR2S & GR2BW Series Installation & Operating Manual I&W #07. 05. 079. 00 This manual contains important safety information concerning the maintenance, use and operation of this product. Failure to follow the instructions contained in this manual may result in serious injury. If you are unable to understand the contents of this manual, please bring it to the attention of your supervisor. Do not operate this equipment unless you have read and understood the contents of this manual. Este manual contiene importante información sobre seguridad concerniente al mantenimiento, uso y operación de este producto. [. . . ] Position the acrylic breath protector(s) side with holes into the slotted channel. Align holes in acrylic with holes in channel. Install thumbscrews into channel, through acrylic and then tighten screws until snug. Installing Breath Protector LOCATION CAUTION Locate the unit at the proper counter height, in an area that is convenient for use. The location should be level to prevent the cabinet or its contents from accidentally falling, and strong enough to support the weight of the unit and food. WARNING For safe and proper operation, the unit must be located a reasonable distance from combustible walls and materials. If safe distances are not maintained, discoloration or combustion could occur. For safe and proper operation locate the unit indoors where the ambient air temperature is constant and is a minimum of 70°F (21°C). Form No. GR2S/2BWM-0203 6 OPERATION ALL MODELS CAUTION Some exterior surfaces on the unit will get hot. Use caution when touching these areas to avoid injury. Plug unit into an electrical outlet of the correct voltage, size and plug configuration. WARNING To prevent any injury or damage to the unit do not pull unit by power cord. Turn the main toggle switch to the ON position. Indicator light will glow when unit is energized. Turn the thermostat to the desired temperature settings. (Toggle switch must be ON for thermostat to function. ) 4. Allow unit 15-20 minutes to reach operating temperature. WARNING For safe and proper operation do not place food product directly onto hardcoat surface. Food product must be wrapped, boxed or on a food pan. OFF ON ON/OFF Toggle Switch 80 F 28 C 200 F 93 C HATCO CORPORATION, Milwaukee, WI Indicator Light Thermostat Control Figure 6. Operating Controls - GR2S ON/OFF Toggle Switch LOW 0 OFF 1 7 6 3 4 5 HIGH Thermostat Control 0 OFF l 2 ON 80 F 28 C 200 F 93 C HATCO CORPORATION, Milwaukee, WI Indicator Light Infinite Control Figure 7. Operating Controls - GR2BW GR2BW ONLY The infrared heat and incandescent lights are controlled by the toggle switch. This switch must be in the ON position when in use. [. . . ] San Francisco COLORADO Hawkins Commercial Appliance Englewood 303-781-5548 DELAWARE Food Equipment Service Wilmington 302-996-9363 FLORIDA Whaley Foodservice Repair Jacksonville 904-725-7800 Nass Service Co. , Inc. Pompano Beach 954-971-0456 650-635-1900 Electrical Appl. Repair Service Independence 216-459-8700 E. Oklahoma City 405-235-2184 Krueger, Inc. [. . . ]