User manual HATCO GR3M-0905(1)

[. . . ] GLO-RAY® Heated Glass Overshelves GR3 & GR3L Series Installation & Operating Manual I&W #07. 05. 154. 00 This manual contains important safety information concerning the maintenance, use and operation of this product. Failure to follow the instructions contained in this manual may result in serious injury. If you're unable to understand the contents of this manual, please bring it to the attention of your supervisor. Do not operate this equipment unless you have read and understood the contents of this manual. Este manual contiene importante información sobre seguridad concerniente al mantenimiento, uso y operación de este producto. [. . . ] For other countertop materials, drill holes through countertop and secure with bolts and nuts. Units mounted to a metal surface may require a backing plate installed to the underside of the surface in order to increase unit stability (backing plate not supplied). Secure counter mount covers in place using original hardware. CAUTION Use of excessive force when tightening mounting screws may damage unit or countertop. NOTE: Hatco recommends a qualified electrician connect the appropriate electrical power source to the Remote Control Box. Refer to SPECIFICATIONS WIRING DIAGRAM, or the unit identification plate for specific model watt and amp ratings. Connect incoming power supply to the wire leads inside the Remote Control Box. Wire leads are factory attached to the Ground Fault Circuit Interrupt (GFCI) switch. 10. Route wires located in the Flexible Conduit through knock outs located on either end of the Remote Control Box. Secure Flexible Conduit to the Remote Control Box. 12. Connect heating unit and lights by attaching the Flexible Conduit wires to the terminal block located inside the Remote Control Box. (See WIRING DIAGRAM for details. ) Screw (Not Supplied) Mounting Bracket Conduit Hole Top View 1. 5" (38 mm) Counter Mount Cover Flexible Conduit 2" (51 mm) 11. 5" (292 mm) Mounting Template Nut (Not Supplied) Figure 3. GR3M-0905 6 INSTALLATION REMOTE MOUNTED CONTROL BOX (RMB) Remote mounted control box should be installed by a qualified electrician. NOTE: When mounting the remote mounted control box insure space is available to access the GFCI reset button. CAUTION The Remote Mounted Control Box must be installed outside of the heat zone. Locating the control box inside the heat zone will cause the switches to overheat, malfunction, and fail. See Figure 5 for minimum mounting distances. Figure 4. Minimum Remote Mounting Distance for Remote Control Box 7 Form No. GR3M-0905 OPERATION WARNING To avoid any injury, do not allow liquids to spill onto the Heated Glass Overshelf. To avoid electrical shock or personal injury DO NOT submerge in water. Do not operate if it has been submerged in water. WARNING For safe and proper operation do not place food product directly onto glass surface. [. . . ] Repair Service Independence 216-459-8700 E. Oklahoma City 405-235-2184 Krueger, Inc. Oklahoma City OREGON Ron's Service, Inc. Portland PENNSYLVANIA Elmer Schultz Services Philadelphia 215-627-5401 FAST Comm. [. . . ]