User manual HATCO GRFHSM-0203(2)

[. . . ] GLO-RAY GRFHS Series ® Fry Holding Station Installation & Operating Manual I&W #07. 05. 107. 00 This manual contains important safety information concerning the maintenance, use and operation of this product. Failure to follow the instructions contained in this manual may result in serious injury. If you are unable to understand the contents of this manual, please bring it to the attention of your supervisor. Do not operate this equipment unless you have read and understood the contents of this manual. Este manual contiene importante información sobre seguridad concerniente al mantenimiento, uso y operación de este producto. [. . . ] If safe distances are not maintained, discoloration or combustion could occur. For safe and proper operation locate the unit indoors where the ambient air temperature is constant and is a minimum of 70°F (21°C). Trivet Figure 5. Installation (GRFHS-PT26 shown) CAUTION To prevent any injury or damage locate the unit at the proper counter height, in an area that is convenient for use. WARNING This product has no "user" serviceable parts. To avoid damage to the unit or injury to personnel, use only Authorized Hatco Service Agents and Genuine Hatco Parts when service is required. WARNING Genuine Hatco Replacement Parts are specified to operate safely in the environments in which they are used. Some aftermarket or generic replacement parts do not have the characteristics that will allow them to operate safely in Hatco equipment. It is essential to use Hatco Replacement Parts when repairing Hatco equipment. Failure to use Hatco Replacement Parts may subject operators of the equipment to hazardous electrical voltage, resulting in electrical shock or burn. CLEANING CAUTION Use only non-abrasive cleaners. Abrasive cleaners could scratch the finish of your Glo-Ray Fry Holding Station, marring its appearance and making it susceptible to dirt accumulation. To preserve the bright finish of the Glo-Ray Fry Holding Station, it is recommended that the exterior and interior surfaces be wiped daily with a damp cloth. Stubborn stains may be removed with a good non-abrasive cleaner. Hard-to-reach areas should be cleaned with a soft brush and mild soap. Remove stainless steel trivet, divider and any accessories for proper cleaning in dishwasher or pot and pan sink. DISPLAY LIGHT BULB REPLACEMENT The display light is an incandescent light bulb which illuminates the warming area. The bulb has a special coating to guard against injury and food contamination in the event of breakage. To replace a light bulb, disconnect the power supply and wait until the unit has cooled. Unscrew the light bulb from the unit and replace it with a new specially coated incandescent light bulb. NOTE: Hatco shatter-resistant light bulbs meet N. S. F. standards for food holding and display areas. For 100 and 120 volt applications, use Hatco part #02. 30. 043. 00. For 220-230 and 230-240 volt, use Hatco part #02. 30. 058. 00. Form No. GRFHSM-0203 6 ACCESSORIES ACCESSORIES The following accessories can be supplied to customize your Fry Holding Station bin. [. . . ] San Francisco COLORADO Hawkins Commercial Appliance Englewood 303-781-5548 DELAWARE Food Equipment Service Wilmington 302-996-9363 FLORIDA Whaley Foodservice Repair Jacksonville 904-725-7800 Nass Service Co. , Inc. Pompano Beach 954-971-0456 650-635-1900 Electrical Appl. Repair Service Independence 216-459-8700 E. Oklahoma City 405-235-2184 Krueger, Inc. [. . . ]