User manual HATCO HDW1R2M-0502

[. . . ] DRAWER WARMER HDW-1R2 Series Installation & Operating Manual I & W #07. 05. 123. 00 This manual contains important safety information concerning the maintenance, use and operation of this product. Failure to follow the instructions contained in this manual may result in serious injury. If you're unable to understand the contents of this manual, please bring it to the attention of your supervisor. Do not operate this equipment unless you have read and understood the contents of this manual. Este manual contiene importante información sobre seguridad concerniente al mantenimiento, uso y operación de este producto. [. . . ] HDW1R2M-0502 2 SPECIFICATIONS ELECTRICAL RATING CHART - HDW-1R2 MODEL Model HDW-1R2 Voltage 120 Watts 525 Amps 4. 4 Plug Configuration NEMA 5-15P Shipping Weight 97 lbs. (44 kg) DIMENSIONS - HDW-1R2 Depth (A) 16-5/8" (42 cm) Width (B) 29-1/4" (74 cm) Height (C) 11" (28 cm) Height (D) 4" (10 cm) C D A B Model HDW-1R2 3 Form No. HDW1R2M-0502 INSTALLATION HDW-1R2 MODEL Care should be taken when unpacking shipping carton to avoid damage to unit and components enclosed. Remove plastic bag containing four adjustable legs from inside the drawer. CAUTION The National Sanitation Foundation (NSF) requires that HDW-1R2 Series units over 36" (91 cm) in length or weighing more than 80 lbs. (36 kg) to be either sealed or raised on the installation surface. If this unit cannot be sealed at the point of use, 4" (10 cm) legs are included to allow for proper cleaning access below unit. See INSTALLATION instructions for details. Carefully lay unit on its side (requires 2 people). Install legs to bottom of unit as shown in Figure 3. CAUTION Do not lay unit on the front or back side or damage to unit could occur. NOTE: Legs are adjustable for leveling the unit. Use a 9/16" (14 mm) open-end wrench to make leveling adjustments once the unit is placed in final position. Figure 3. Adjustable Legs Leg Adjustment Adjust leg using a 9/16" (14 mm) open-end wrench and turning bottom of leg accordingly. Leg Installation LOCATION CAUTION Locate the unit at the proper counter height, in an area that is convenient for use. The location should be level to prevent the unit or its contents from accidentally falling, and strong enough to support the weight of the unit and food. WARNING For safe and proper operation, the unit must be located a reasonable distance from combustible walls and materials. If safe distances are not maintained, discoloration or combustion could occur. Form No. HDW1R2M-0502 4 OPERATION ALL MODELS WARNING Some exterior surfaces on the unit will get hot. Use caution when touching these areas to avoid injury. On HDW-1R2 series, plug unit into an electrical outlet of the correct voltage, size and plug configuration. Turn the Power Switch to the ON position. Turn the Thermostat Control to the desired temperature settings. [. . . ] Pompano Beach 954-971-0456 650-635-1900 Electrical Appl. Repair Service Independence 216-459-8700 E. Oklahoma City 405-235-2184 Krueger, Inc. Oklahoma City OREGON Bressie Electric Co. [. . . ]