User manual HAUPPAUGE WINTV-PVR-USB2 MCE

[. . . ] SE1 9QQ www. hauppauge. com Included with WinTV-PVR-USB2 MCE: · · · · · · · WinTV-PVR-USB2 box, with 125 channel cable ready TV tuner, FM radio receiver, MPEG-2 hardware audio/video compressor FM radio antenna Wall mounted power supply WinTV-PVR MCE Driver Installation CD-ROM with drivers for Windows XP Media Center Edition 2005 WinTV-PVR-USB2 MCE Quick Installation Guide (this guide) Remote control transmitter with batteries (some models) Remote control receiver (USB) with IR "blaster" for controlling external set top boxes (some models) 1 Installing the WinTV-PVR-USB2 MCE The WinTV-PVR-USB2 MCE is an external USB2. 0 device with a built-in TV tuner plus FM radio and hardware MPEG encoder. The WinTV-PVR-USB2 MCE differs from the retail WinTV-PVR-USB2 version in that the MCE version does not include a built-in remote control receiver since Media Center requires its own unique USB connected remote control device. To sucessfully configure a Windows XP Media Center 2005 system with TV and remote control, you will need to install the Hauppauge WinTV-PVR-USB2 and a Media Center remote control transmitter and receiver (included in some models). Installation overview To install WinTV-PVR-USB2 MCE, you will follow these steps: Step 1. [. . . ] Insert the WinTV-PVR MCE Driver Installation CD-ROM in your PC's CD-ROM drive and make sure Install the software automatically (Recommended) is checked. The WinTV-PVR-USB2 drivers will automatically install. Click Finish. Removing the WinTV-PVR driver If you ever need to remove the WinTV driver, run HCWClear. EXE from the WinTV-PVR MCE Installation CD-ROM. WinTV-PVR-USB2 setup under Media Center Edition 2005 If you are using the WinTV-PVR under Windows XP Media Center Edition 2005, you should run the TV Setup Wizard in Media Center. Normally, the next time you run Media Center after the installation of a new TV tuner, the Setup Wizard will run. This might not happen if you had previously installed a different TV tuner board or USB device. To manually launch the TV Set Up Wizard, in the main Media Center menu go to Settings / TV / Set up TV Signal. You will see a message: Set Up Your TV Signal. You will then see Chose your Region, select your region and click Next. If you are using WinTV-PVR-USB2 for receiving analog TV, you will see the message Select cable, satellite, Antenna or no signal at this time. You will then be asked if you have a Set top box?Click Next. N ote: at this point, Media Center Edition will set up the TV tuner. This might take a minute or so. 3 After Media Center returns with the You're Done!message, your WinTV-PVR will have been set up by Media Center Edition. Now, you need to set up the Electronic Program Guide. Media Center should automatically launch the Guide set up. You will see a message: Set Up Your Program Guide. [. . . ] Click the Start button on the taskbar, point to All Programs, and then click Set Program Access and Defaults. Click the down arrow button to expand the option. Under Choose a default media player, select the check box next to Media Center Radio. [. . . ]