User manual HAWKING HCF30W DOCUMENT

[. . . ] Operation is subject to the following two conditions: 1) This device may not cause harmful interface, and 2) This device must accept any interface received, including interface that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] Then click ok. -8- Use server-assigned IP address If your network does not support DHCP, select Use specific IP address. You may need to enter the IP address and other information. When you have finished entering settings, click OK. If you forget to click OK, your settings will not take effect!A message as below may appear saying you must remove and re-insert the Wireless CompactFlash Card to have the changes take affect. Click OK. -9- After installing the H-CF30W Wireless CompactFlash Card's driver successfully, go to Start Programs. Click on PRISM Settings, the Network Status icon will appear in the task bar. - 10 - Network Status Icon & Icon Menu The Status Icon Icon Link Status Green indicates a strong link. Red indicates no or a very poor link. Icon Menu After clicking on the icon, the icon menu as displayed below will prompt you to configure the H-CF30W Wireless CompactFlash Card. - 11 - Items Wireless Radio On Wireless Radio Off Description These two items allow you to enable or disable the wireless radio. Removes the Utility icon from the PDA's system tray. Each time you power on your PDA, the icon will reappear. Clicking these items will Wireless Network launch the Wireless Status Settings window, as Advanced described below. Version Information. . . All settings are categorized into 5 tabs: Link Configuration Encryption Site Survey About Link The Link tab displays the status of the H-CF30W. - 12 - Item State Description It displays the connection state of the Wireless CompactFlash Card with the wireless network. It displays the selected channel Current that is currently used. (There are Channel 14 channels available, depends on the country. ) Click this button to enable/disable Enable Radio the wireless radio. The Wireless / Disable Radio CompactFlash Card will connect/disconnect with the wireless network. Rescan Clicking on the button, the device will start to rescan. Current Tx It displays the current transfer Rate rate. It displays the transferring (Tx) Throughput and receiving (Rx) data rate in bytes per second. - 13 - Description It displays the link quality of the Link Quality connection between the Wireless CompactFlash Card and the Access Point or Peer-to-Peer type it connects. Signal Strength It displays the signal strength of the connection between the Wireless CompactFlash Card and the Access Point or Peer-to-Peer type it connects. Item Configuration The Configuration tab allows you to set parameters for the Wireless CompactFlash Card. - 14 - Item Description Saves values for all previous setting Profile parameters. The default values contain the parameters configured at Name installation. Once the demands for switching between different networking environments are met, you can set the additional profiles to reduce the configuration time. To save the current parameters, highlight the Profile field, type a new name, and click on the Apply button. A specific name shared among Network connected Wireless CompactFlash Name Card, Access Points and other wireless stations on the wireless network. [. . . ] A set of wireless stations is referred to as a Basic Service Set (BSS). Computers in a BSS must be configured with the same BSS ID. It shows the selected channel that is currently used. Access Point: allows the Adapter to communicate with a wired network which employing an Access Point. [. . . ]