User manual HEAT AND GLO LUX60

[. . . ] Owner's Manual Installation and Operation Model(s): LUX60 CAUTION T O N RD OA D SC I D DO NOT DISCARD THIS MANUAL · Important operating and · Read, understand and follow · Leave this manual with party responsible for maintenance instructions these instructions for safe installation and operation. included. WARNING If the information in these instructions is not followed exactly, a fire may result causing property damage, personal injury, or death. · Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. · What to do if you smell gas: - Do not try to light any appliance. [. . . ] M Clearance under veranda, porch, deck or balcony - 12 in. Only permitted if veranda, porch, deck or balcony is fully open on a minimum of 2 sides beneath the floor. * N Vertical clearance between two horizontal termination caps ­ 12 in. O Horizontal clearance between two horizontal termination caps ­ 12 in. Figure 6. 3 Minimum Clearances for Termination P 6" - Non-vinyl sidewalls 12" ­ Vinyl sidewalls Q 18" ­ Non-vinyl soffit and overhang 42" ­ Vinyl soffit and overhang R 8 ft. S min 1 cap 2 caps 3 caps 4 caps S min = # term caps x 3 3 ft 6 ft 9 ft 12 ft T max 2 x S actual 1 x S actual 2/3 x S actual 1/2 x S actual T max = (2/# term caps) x S (actual) U 6" min. ­ Clearance from sides of electrical service. ­ Clearance above electrical service. * As specified in CGA B149 Installation Codes Note: Local codes or regulations may require different clearances. ** Clearance required to vinyl soffit material ­ 30 in. Note: Location of the vent termination must not interfere with access to the electrical service. WARNING!In the U. S. : Vent system termination is NOT permitted in screened porches. You must follow side wall, overhang and ground clearances as stated in the instructions. In Canada: Vent system termination is NOT permitted in screened porches. Vent system termination is permitted in porch areas with two or more sides open. You must follow all side wall, overhang and ground clearances as stated in the instructions. Hearth & Home Technologies assumes no responsibility for the improper performance of the appliance when the venting system does not meet these requirements. CAUTION: IF EXTERIOR WALLS ARE FINISHED WITH VINYL SIDING, IT IS SUGGESTED THAT A VINYL PROTECTOR KIT BE INSTALLED. 26 Heat & Glo · LUX60 · 4062-116 · Rev D · 9/09 7 Vent Information and Diagrams A. Approved Pipe This appliance is approved for use with Hearth & Home Technologies DVP venting systems. DO NOT mix pipe, fittings or joining methods from different manufacturers. The pipe is tested to be run inside an enclosed wall. There is no requirement for inspection openings at each joint within the wall. This appliance requires a separate vent. DO NOT vent to a pipe serving a separate solid fuel burning appliance. Horizontal 8-1/2 in. 4 6 12 24 36 48 3-6 3 - 12 Vertical 12 in . 8-1/2 in. B. [. . . ] (384 mm) Term Cap Trap1 79 mm 117 mm 9-3/8 in. 238 mm Minimum Effective Length 3-1/8 in. Maximum Effective Length 4-5/8 in. 12 in. (305 mm) Max Effective Length 5-3/8 in. [. . . ]