Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual HERKULES 11969. We hope that this HERKULES 11969 user guide will be useful to you.
Lastmanuals help download the user guide HERKULES 11969.
Detailed instructions for use are in the User's Guide.
[. . . ] Part# 1002391 7/15/2005
INSTALLATION INSTRUCTIONS
11969 TIMED DIAPHRAGM PUMP CONVERSION ASSEMBLY
FOR CONVERTING A MANUAL SHUT OFF GUN WASHER FROM A PISTON PUMP TO A DIAPHRAGM PUMP
Removal of Gun Washer's Piston Pump Assembly Disconnect shop air line from Gun Washer. Disconnect the solvent tube fittings at the tub inlet and outlet locations. [. . . ] Grounding the Gun Washer
1) Attach the ground clamp from the pump
bulkhead on the side of the tub (see fig. 2).
4) Connect the two rubber tubes between
housing to the upper bulkhead on the side of the gun washer tub (see fig. Connect the coiled ground wire attached at the front of the pump to the shop's ground. Route the wire through the housing and out the back. Connecting the air to the Gun Washer
1) Install your own 1/4" male connector into the
the pump and the tub (see fig. Use finger force to engage threads on flare nuts. a) Connect the shorter, 1/2" diameter tube from the "Material Outlet" of the pump to the upper bulkhead of the tub. Finger tighten.
b) Connect the longer, 3/4" diameter tube
from the "Material Inlet" of the pump to the lower bulkhead of the tub. Finger tighten.
c) When the housing and solvent tubes are
filter-regulator inlet at the back of the pump housing. IMPORTANT: Hand tighten your air coupler male connector into the filter-regulator inlet. Then, wrench tighten it 1/4 turn only.
2) Connect a shop air line of 65-120 psi. The paint
aligned, tighten the four flare nuts
5) Tighten the diaphragm pump housing's two
gun washer's filter-regulator is factory preset and locked at 75 psi. [. . . ] To re-start the gun washer, turn the timer knob again.
6) For a full 90 second timing cycle, turn the
knob clockwise 90 degrees. Turning the knob less than 90 degrees will reduce the timing cycle.
Page 3 of 3 [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE HERKULES 11969
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual HERKULES 11969 will begin.
