User manual HERKULES 11981

[. . . ] Part# 1002389 7/13/2005 INSTALLATION INSTRUCTIONS 11981 TIMED DIAPHRAGM PUMP CONVERSION ASSEMBLY FOR CONVERTING A TIMED GUN WASHER FROM A PISTON PUMP TO A DIAPHRAGM PUMP Plastic Bag Contents · Installation Instructions · 2 nuts, 2 flat washers, 2 lock washers, and · · · · Assembling Diaphragm Pump Housing onto Gun Washer 1) Loosely mount the 11981 diaphragm pump 2 nylon spacers Solvent intake filter 2 steel tubes with flare nuts. Operating instructions decal for washer lid Owner's Manual: GW/R-T-OM assembly onto the gun washer stand. [. . . ] Finger tighten. b) Connect the longer, 1/2" diameter tube Note: To remove air lines use a fingernail or screw driver to press in brass collar on the roller switch, then pull on tubing to remove. 8) Remove piston pump saddle clamp from Gun between the "Material Inlet" of the pump to the lower bulkhead of the tub. Finger tighten. c) When the housing and solvent tubes are Washer frame. Dispose of the entire piston pump assembly, including the timer tube. aligned, tighten the four flare nuts 4) Tighten the diaphragm pump housing's two 1/4-20 x 1" hex head bolts, washers, and nuts as loosely assembled in step 1. Herkules Equipment Corporation 2760 Ridgeway Court Walled Lake, MI 48390-1662 USA 248-960-7100 1-800-444-4351 Fax 248-960-7109 www. herkulesequipment. com info@herkules. us 5) Connect the blue plastic air tubing running from 7) Connect a shop air line of 65-120 psi. The paint the housing (timer cut off switch) to the in port of the safety shut-off switch at the lid. The switch is shielded by an aluminum panel. Press tubing in through the collar until seated in the black, roller safety shut-off switch. Then, pull firmly to test for a tight connection. In the same way, connect the black plastic air tubing line running from housing (pump) to the out port of the safety shut-off switch at the lid. Again press tubing in through the collar until seated in the roller safety shut-off switch. Then, pull firmly to test for a tight connection. 6) Install your own 1/4" male connector into the gun washer's filter-regulator is factory preset and locked at 65 psi. DO NOT ATTEMPT TO CHANGE THIS SETTING. 8) Connect the coiled ground wire attached at the front of the pump to the shop's ground. Route the wire through the housing and out the back. #M1 #M1C OUT PORT filter-regulator inlet at the back of the pump housing. [. . . ] This starts the pump and the timer. knob clockwise 90 degrees. Turning the knob less than 90 degrees will reduce the timing cycle. [. . . ]