User manual HILTI CA3200 INSTALLATION

[. . . ] 7. 2. 5. 3 INSTALLATION DATA Basic Use CA3200 bonds to most common building materials including: wood, plaster, concrete and masonry. [. . . ] Material to be adhered should be partially nailed or braced to aid alignment during installation. When used for installing paneling, all panels should be measured and prefit, and cutouts for switches and outlets completed before applying adhesive. To speed bond development, materials should be pressed into position, then removed for one minute and repressed. Apply only as much CA3200 as can be covered in 15 minutes. For best results, store at room temperature and use entire contents of tube once it has been opened. Surface Preparation All surfaces should be clean, dry and free from all contaminants such as oil and grease. For Bonding Foam Products--Foam Installations: If adhering directly to wall, grind off excessive mortar and other high areas from wall surface. For polystyrene foam, apply a maximum 1/4" bead of adhesive. [. . . ] Cleaning Tools and excess adhesive should be cleaned with mineral spirits. [. . . ]