User manual HILTI DX 860- HSN

[. . . ] DX 860-HSN Operating Instructions 1 2 3 1 2 5 6x 6 4 1 2 2 1 7 A h B h 8 C h D 2/4 9 10 2 1 1 3 11 3 8 5 7 4 10 9 2 1 11 12 3 2 4 1 5 6 10 7 9 8 11 14 12 13 DX 860-HSN powder-actuated fastening tool 1. General information It is essential that the operating instructions are read before the tool is operated for the first time. Always keep these operating instructions together with the tool. Ensure that the operating instructions are with the tool when it is given to other persons. Parts of the tool 1. [. . . ] Set the power regulation wheel to position 1. On the site of the cartridge feeding channel, push the cartridge strip forward until you can pull the strip out of the tool at the cartridge strip exit aperture. -NOTENever try to push or pull the cartridge strip against the direction of standard strip advance, 7. 3. 2 Removing fastener strips form the fastener loading channel [10] -NOTE- 7. 2 Remedying faults 7. 2. 1 If a cartridge fails to ignite when the tool is actuated, proceed as follows: 1. Keep the tool pressed against the work surface for 30 seconds. If the cartridge still does not ignite, withdraw the tool from the work surface and advance the cartridge strip manually, and continue to use the remaining cartridges in the strip. At the cartridge loading side, advance the cartridge strip by one cartridge by pushing the strip further into the tool or, alternatively, by pulling the strip through the tool by hand at the cartridge strip exit aperture. It is not absolutely necessary to remove fastener strips from the tool. . -WARNINGCheck that no cartridges are present in the tool. If necessary, unload the tool as described at section 7. 3. 1. Stand the tool upright on the grip (upside down). Use the scraper (supplied with the tool) to push the fastener strips back through the loading channel. 3. Press the red button above the magazine and allow the fasteners to slide out of the magazine. 8. Care and maintenance When this type of tool is used under normal operating conditions, dirt and residues build up inside it and functionally relevant parts are subject to wear. Regular inspections and maintenance are thus essential in order to help ensure reliable operation: · The operating controls and the condition of the piston and piston brake must be checked daily, or, at the latest, after every 5, 000 fasteners (see section 8. 2. 1). · The maintenance procedures described at section 8. 2 must be carried out after every 15, 000 fasteners, or earlier if operation of the tool becomes stiff. -WARNINGCartridge strips must be unloaded from the tool before carrying out care and maintenance. -CAUTION- When cleaning: Never use grease for the maintenance / lubrication of parts of the tool. Use only Hilti lubricant spray or a product of comparable quality. The residues deposited inside DX tools contain substances that may be injurious to your health: Do not inhale any dust or dirt while cleaning. Keep the dust or dirt away from foodstuffs. Wash your hands after cleaning the tool. 8. 2. 1 Checking the piston and/or piston brake [11] -WARNINGCheck that cartridges are unloaded from the tool 1. Stand the tool on its grip (upside down). [. . . ] Load fasteners Load fastener strips [3]; check that strips are free to move; remove any damaged or distorted fastener strips [10]. Screw the magazine on fully. Contact your local Hilti Representative . Fastener guide needs to be Clean the baseplate and cleaned. adjoining parts with the cleaning brushes provided. [. . . ]