User manual HILTI PD32

[. . . ] PD 32 en fr it pt es Operating instructions Mode d'emploi Istruzioni d'uso Manual de instruções Manual de instrucciones 1­26 27­52 53­78 79­104 105­130 282401 *282401* 5 2 9 10 9 7 10 4 8 6 31 PDA 50 PDA 80 PDA 60 PDA 81 PDA 61 PDAW 80-1 PDA 62 PDAW 80 / 81-1 PDA 70 PDAW 80 / 81-2 PA 970 PDAW 80 / 81-3 PDAW 81-1 PD 32 laser range meter It is essential that the operating instructions are read before the range meter is used the first time. Always keep these operating instructions together with the tool. Ensure that the operating instructions are with the range meter when it is given to other persons. Contents Contents 1. 3 Safety notices and their meaning 3 Pictograms . [. . . ] The display shows this aiming mode as an animated dashed line 7. 4. 3 Measuring mode Two different measuring modes are available to measure distances. These are single distance measurement and continuous distance measurement. The continuous measurement mode is used for setting out given distances or offsets and is also used where distance measurements are more difficult, e. g. to corners, edges, niches, etc. 16 7. Operation 7. 4. 3. 1 Single distance measurement (Measure key) 1. Switch on the laser beam by pressing the "Measure" key. Press the "Measure" key once again. Generally, the measured distance will be completed in less than a second and shown in the result line. - NOTE Alternatively the range meter may be switched on by pressing the On key and the laser then activated by pressing the measure key. 7. 4. 3. 2 Continuous measurement Press the "Measure" key for about 2 seconds to activate this measuring mode. When doing so, it does not matter whether or not the range meter is off or the laser beam is switched on or off. The range meter will always switch to continuous measurement. During continuous measurement, the distances are updated in the result line by about 8 to 15 measurements every second. This depends on the reflectivity of the target surface. If the beep signal is switched on, continuous measurement is indicated by a Beep. The measuring process is stopped by pressing the "Measure" key once again. On doing so, the last valid distance measurement shows in the result line on the display. - NOTE Continuous measurement is possible wherever distances can be measured. This applies also to functions, such as areas and volumes. 7. 4. 4 Measuring from corners The spike is used when measuring diagonally across rooms or from inaccessible corners. This automatically sets the measuring reference to the end of the spike. The range meter takes the extended reference point into account and corrects the measured distances accordingly. 2. [. . . ] Should you wish to return a range meter, etc. , to a disposal facility yourself for recycling, dismantle it as far as this is possible without the need for special tools. Separate the individual parts as follows: Part / assembly Casing Main material Plastic Recycling as Plastic / scrap metal Plastic scrap metal Electronics scrap * Plastic scrap 12. Warranty Hilti warrants that the product supplied is free of defects in material and workmanship. This warranty is valid as long as the product is operated and handled correctly, cleaned and serviced properly and in accordance with the Hilti operating instructions, all warranty claims are made within 12 months from the date of the sale (invoice date), and the technical system is maintained. [. . . ]