User manual HILTI PMP32

[. . . ] PMP 32 plumb laser It is essential that the operating instructions are read before the tool is operated for the first time. Always keep these operating instructions together with the tool. Ensure that the operating instructions are with the tool when it is given to other persons. Component parts Laser exit windows Magnets Selector button LED indicator en Contents 1. Manufacturer's warranty ­ tools 13. [. . . ] CLASS II LASER PRODUCT This laser product complies with CFR 21 § 1040 (FDA) as applicable. 5. 5 General safety precautions Check the tool for possible damage or dirt before use. If the tool is found to be damaged, have it repaired at a Hilti service center. The accuracy of the tool must be checked after it has been dropped or subjected to other mechanical stresses. When the tool is brought into a warm environment from very cold conditions, or vice-versa, allow it to become acclimatized before use. If mounting on an adaptor, ensure that the tool is attached securely. Keep the laser exit aperture clean to avoid measurement errors. Although the tool is designed for the tough conditions of jobsite use, as with other optical instruments (binoculars, spectacles, cameras) it should be treated with care. Although the tool is protected to prevent entry of dampness, it should be wiped dry each time before being put away in its Hilti toolbox. 5. 5. 1 Electrical hazards The batteries must be insulated or removed from the tool before it is shipped. The tool and the batteries must be disposed of in accordance with national regulations in order to avoid environmental pollution. Consult the manufacturer if you are unsure. 7 6. Before use en 6. 1 Inserting new batteries -NOTEDo not use damaged batteries. Do not mix batteries of different makes or types. Pull the battery compartment release button . -CAUTIONTake care to observe correct polarity. Operation & applications 7. 1 Operation -NOTEThe pendulum is able to swing freely when the tool is set up in a horizontal position ( ± 4°). The laser beams blink rapidly when the tool is unable to level itself automatically. The best accuracy results are obtained on a leveled surface. 7. 1. 1 Switching on the laser beams Switching on the plumb beams (vertically upwards and downwards): 1. 8 7. 1. 2 Switching the tool/laser beams off 1. -NOTEThe tool switches itself off automatically after approx. 7. 1. 3 Deactivating the automatic cut-out 1. [. . . ] For EC countries only Disposal of electric tools together with household waste is not permissible!In observance of European Directive 2002/96/EC on waste electrical and electronic equipment and its implementation in accordance with national law, electric tools that have reached the end of their life must be collected separately and returned to an environmentally compatible recycling facility. 13 12. Manufacturer's warranty ­ tools Hilti warrants that the tool supplied is free of defects in material and workmanship. This warranty is valid so long as the tool is operated and handled correctly, cleaned and serviced properly and in accordance with the Hilti Operating Instructions, and the technical system is maintained. [. . . ]