User manual HILTI SFL 36

[. . . ] Declaration of conformity Page 5 6 6 6 6 6 6 7 7 7 8 5 2. Description The tool is manufactured from high-grade, impact-resistant plastic. The battery and charger are not supplied with the tool. 2. 1 Correct use The tool is designed to provide light while working on construction sites. [. . . ] Never store the battery at high temperatures, i. e. exposed to the direct heat of the sun, on radiators, behind a motor vehicle windscreen or at a window. Do not use the battery until the bulb no longer lights. The battery cells may suffer damage if allowed to become completely discharged. 4. Technical data SFL12/15 SFL 18 SFL 24 SFL 36 Voltage 12 V / 15. 6 V 18V 24V 36V Light bulb Xenon 15. 6 V / 0. 7 A Krypton 18 V / 0. 65 A Krypton 18 V / 0. 65 A Krypton 18 V / 0. 65 A 5. Safety precautions In addition to the information relevant to safety given in each of the sections of these operating instructions, the following points must be strictly observed at all times. The tool must always be operated correctly, in accordance with the operating instructions and only when in a complete and undamaged state. Operation 7. 1 Switching the tool on Press the on / off switch for SFL12/15, SFL 18, SFL 24, SFL 36. 7. 2 Switching the tool off Press the on / off switch for SFL12/15, SFL 18, SFL 24, SFL 36. 7. 3 Pivoting the flashlight head SFL 12/15, SFL 18 The flashlight head can be pivoted up to 90°. Please note that the flashlight head can be pivoted only in one direction, i. e. from the straight-ahead position in a counterclockwise direction. SFL 24, SFL 36 The flashlight head can be pivoted up to 45°. Please note that the flashlight head can be pivoted only in one direction. Risk of dazzling: Do not direct the flashlight toward yourself or other persons. your Hilti customer service department or Hilti sales representative for further information. Should you wish to return the electric tool yourself to a disposal facility for recycling, proceed as follows: Dismantle the tool as far as possible without the need for special tools. Separate the individual parts as follows: Part / assembly Main material Recycling Outer casing 8. Care and maintenance 8. 1 Care of the tool The outer casing of the tool is manufactured from impactresistant plastic. The grip sections are manufactured from synthetic rubber. Clean the outside of the tool at regular intervals with a slightly damp cloth. Do not use a spray cleaning system, high-pressure steam cleaning system or running water for cleaning. These may negatively affect the electrical safety of the tool. Always keep the grip sections of the tool free from oil and grease. [. . . ] For repair or replacement, send tool and/or related parts immediately upon discovery of the defect to the address of the local Hilti marketing organization provided. This constitutes Hilti's entire obligation with regard to warranty and supersedes all prior or contemporaneous comments and oral or written agreements concerning warranties. Disposal Most of the materials from which Hilti power tools are manufactured can be recycled. The materials must be correctly separated before they can be recycled. [. . . ]