User manual HILTI SMD57

[. . . ] Make a note of this data in your operating instructions and al- ways refer to it when making an enquiry to your Hilti representative or service department. Description 2. 1 Use of the product as directed The SMD 57 magazine is an accessory used for driving collated screws. The magazine is suitable for use with the Hilti SF 4000 / SF 4000A / SD 2500 / SD 4500 / SD 5000 and SD 45 screwdrivers. In the safety rules in these operating instructions, the designation "power tool" refers to the magazine. [. . . ] Accordingly, use the switch lockbutton on the screwdriver. c) Do not hold the SMD 57 magazine in the area of the depth gauge. d) Each screwdriving operation must be completed. Stopping half way or releasing pressure on the screwdriver may lead to malfunctions. e) Change the screw strip only when the screwdriver is switched off. f) Wear eye protection, especially when working overhead. 3 en g) Use only genuine Hilti SMBL 116 PH2 bits. Check i) The magazine and Hilti screwdrivers are optimally that the bits are in good condition. h) Use only genuine Hilti screw strips and screws. j) Always work at right angles to the surface of the workpiece to be fastened. k) Store the screw strips in a straight position, as they are in the original package. 7. Before use 7. 1 Fitting the magazine to the screwdriver 3 CAUTION Disconnect the screwdriver's supply cord from the electric supply before fitting the magazine. Remove the depth gauge and bit holder from the screwdriver. Push the magazine onto the screwdriver in the desired working position until it is heard to engage. NOTE The magazine can be engaged on the tool in various positions (every 15°). NOTE Check to ensure that the screwdriver is set to "forward" rotation. 8. Operation 8. 1 Screw length adjustment 4 1. Adjust the depth gauge to suit the length of the screws to be driven. Press the button and slide the depth gauge back or forward. Set the depth gauge to one of the 5 length marks corresponding to the length of the screws. NOTE The correct screw length setting is very important for trouble-free magazine operation. Slide the screw strip through the guide and the channel until the first screw is in position at the mark or until the end of the strip is flush with the upper surface of the magazine at the exit opening. Check that the screw strip has engaged by trying to pull it back gently. [. . . ] This may result in serious personal injury, injury to third parties and pollution of the environment. Most of the materials from which Hilti tools or appliances are manufactured can be recycled. The materials must be correctly separated before they can be recycled. In many countries, Hilti has already made arrangements for taking back your old power tools for recycling. Please ask your Hilti customer service department or Hilti representative for further information. 5 For EC countries only Disposal of electric tools together with municipal waste is not permissible. [. . . ]