User manual HILTI TE 75

[. . . ] Ensure that the operating instructions are with the power tool when it is given to other persons. Contents 1. Manufacturer's warranty - tools 12. EC declaration of conformity Page 17 18 20 20 21 24 25 28 29 30 30 31 Operating controls and parts 1 @ Chuck ; Function selector switch = Control switch % Forward / reverse switch & Side handle with depth gauge ( Interface for TE DRS M dust removal module ) Battery + Release buttons en 1. General information 1. 1 Safety notices and their meaning WARNING Draws attention to a potentially dangerous situation that could lead to serious personal injury or fatality. [. . . ] Release the side handle clamping band by turning the handle counterclockwise. Slide the side handle clamping band over the chuck and onto the cylindrical section at the front end of the power tool. Pivot the side handle into the desired position. Secure the side handle by turning the grip clockwise. 6. 6 Use of the belt adapter NOTE The working weight of the power tool can be reduced by fitting an accessory belt adapter. The battery cannot be charged by way of the belt adapter. NOTE The belt adapter cannot be used in conjunction with Li ion batteries. Observe the instructions given in the section "Safety rules" on safe use of the belt adapter. en 7. Check that the sealing lip of the dust shield is clean and in good condition. Clean the dust shield if necessary or replace it if the sealing lip is found to be damaged (please refer to the "Care and maintenance" section). Push the insert tool into the chuck and rotate it while applying slight pressure until it engages in the guide grooves. Set the forward / reverse switch to the middle position or remove the battery from the power tool. Grip the chuck sleeve, pull it forward and hold it securely in this position. Slide the chuck onto the guide tube from the front and then release the sleeve. Rotate the chuck until it is heard to engage. 7. 2 Operation CAUTION Working on the material may cause it to splinter. Wear eye protection and protective gloves. Wear breathing protection if no dust removal system is used. Splintering material presents a risk of injury to the eyes and body. 7. 2. 1 Working at low temperatures NOTE The hammering mechanism works only when the power tool has reached a minimum operating temperature. Bring the drill bit into contact with the base material and allow the power tool to run under no load until the minimum operating temperature is reached. If necessary, repeat this procedure until the hammering mechanism begins to operate. [. . . ] The forward/reverse switch is set to reverse rotation. The forward / reverse switch is in the middle position (transport lock engaged). The retaining lugs on the battery are dirty. The power tool or the battery gets very warm. Electrical fault. The power tool has been overloaded (application limits exceeded). The function selector switch is not engaged or is set to "Chiseling" or "Chisel adjustment". 29 Fault The insert tool can't be released. [. . . ]