User manual HILTI TE12S

[. . . ] This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install a polarized outlet. Double insulation Z eliminates the need for the three-wire grounded power cord and grounded power supply system. [. . . ] Be sure switch is off before plugging in. Carrying tools with your finger on the switch or plugging in tools that have the switch on invites accidents. 4. 4 Remove adjusting keys or wrenches before turning the tool on. A wrench or a key that is left attached to a rotating part of the tool may result in personal injury. Keep proper footing and balance at all times. Proper footing and balance enables better control of the tool in unexpected situations. Dust mask, non-skid safety shoes, hard hat or hearing protection must be used for appropriate conditions. Tool Use and Care 5. 1 Use clamps or other practical way to secure and support the workpiece to a stable platform. Holding the work by hand or against your body is unstable and may lead to loss of control. 5. 2 Do not force tool. Use the correct tool for your application. The correct tool will do the job better and safer at the rate for which it is designed. Do not use this product in any way other than as directed by these operating instructions. The respective regulations of your trade association and the enclosed General safety rules must be observed. The operating instructions should always be kept with the machine!When working with the machine, it must be held with two hands. Always make sure that you have a safe stance/foothold. The electric supply must be the same as given on the TE 104 nameplate. The TE 104 is double insulated and must not be grounded. Wear protective gloves, safety glasses and ear protectors. 60° Operating when chiselling · Fig. 2: Attach the chisel chuck (change the needle chuck. ) Pull forward locking ring against spring pressure and mount chuck on spindle. Release locking ring and Servicing turn slightly until locking balls engage. Note: The chisel chuck can only be attached Electric tools must comply with the respective safety regulations. [. . . ] les can be replaced separately or as a set. Apply only moderate pressure when working. Insufficient pressure will shorten the life. (Make sure the tool is always in contact with the base material. ) Pointed and narrow flat chisels: Forge chisels at about 900°C to 1000°C (bright red to vright yellow red). [. . . ]