User manual HILTI TE5

[. . . ] Don't force small tool or attachment to do the job of a heavy-duty tool. Don't use tool for purpose not intended ­ for example ­ d'ont use circular saw for cutting tree limbs or logs. Rubber gloves and non-skid footwear are recommended when working outdoors. Wear protective hair covering to contain long hair. [. . . ] Repairs may only be carried out by an electrical specialist otherwise an accident hazard for the operator can exist. Wear ear protectors when using for extended periods. Always use any supplied side handle, and keep it tightly secured; use both hands during operation. Keep proper footing and balance and don't overreach. Firm control of the tool is necessary should the tool bind. Do not touch uninsulated parts of tool when drilling. Exposed metal surfaces may be made live if the tool drills into electrical wiring. When servicing use only identical replacement parts. To reduce the risk of electric shock, this equipment has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way. Please read and take note of these precautions before you use the tool/machine and keep these safety precautions in a safe place! Not recommended 17. When tool is used outdoors, use only extension cords intended for use outdoors and so marked. Before further use of the tool, a SAVE THESE INSTRUCTIONS Hilti TE 5 Rotary Hammer Technical data Power input: Voltage (versions): Current input: Frequency: Weight: Speed under load: Hammering speed under load: Single impact energy: Drill bit diameter range: Recommended range: Drilling performance in B35 concrete: 500 W 230 V 115 V 2. 3 A 4. 6 A 50­60 Hz 2. 8 kg / 6. 2 Ibs 0­800 r. p. m. 0­4000 blows per minute 2. 0 joules / 1. 5 ft-lb 5­20 mm (3/16­3/4) dia. in concrete 5­10 mm (3/16­3/8) dia. (1. 46 in. 3) = 480 mm/min. Double insulation Accessories and kit for Hilti TE5 rotary hammer: Hilti lubricant spray, key-type chuck, quick-release chuck, case or cardboard box dust shield During operation, the sound pressure level may exceed 85 dB (A). In such case, it may be necessary to take suitable protection against the noise. Before beginning work: When working with the machine, it must be held with two hands. Always make sure that you have a safe stance/foothold. Check that the electric supply corresponds to the information on the rating plate. The TE 5 is double insulated and need not be earthed (grounded). [. . . ] The following are recommended American Wire Gauges (AWG) for your TE5: Cord length up to 25 ft. / 7. 6 m: up to 50 ft. /15. 2 m: up to 75 ft. /22. 8 m: AWG 16 14 12 Operation: Fig. 1: Inserting the drill bit Turn chuck towards ( ) symbol and insert the drill bit, turning it until the drive grooves engage and it can be pushed in fully. Lock the chuck by turning it towards the () symbol. Fig. 2: Hammer drilling For hammer drilling in concrete masonry and natural stone, adjust the setting lever to the hammer drilling position ( ) symbol). Drilling without hammering action Adjust the setting lever to the rotary drilling position ( symbol). [. . . ]