User manual HILTI TE60

[. . . ] TE 60 / TE 60-ATC Bedienungsanleitung Operating instructions Mode d'emploi Istruzioni d'uso Manual de instrucciones Manual de instruções Gebruiksaanwijzing Brugsanvisning Bruksanvisning Bruksanvisning Käyttöohje Instrukcija Lietoßanas pamåcîba Kasutusjuhend de en fr it es pt nl da sv no fi el lt lv et 1 2 3 4 5 6 7 8 ORIGINAL OPERATING INSTRUCTIONS TE 60 / TE 60ATC / TE 60T / TE 60TATC combihammer It is essential that the operating instructions are read before the power tool is operated for the first time. Always keep these operating instructions together with the power tool. Ensure that the operating instructions are with the power tool when it is given to other persons. Contents 1. Manufacturer's warranty - tools 12. [. . . ] Slide the side handle clamping band over the chuck and onto the cylindrical section at the front end of the power tool. Pivot the side handle into the desired position. Release the side handle clamping band by turning the handle counterclockwise. Push the depth gauge into the two guide holes in the side handle clamp. Tighten the side handle securely by turning the grip section. This also clamps the depth gauge in position. 25 6. 3 Unlocking the power tool See section "Operation / TPS Theft Protection System (optional)". 6. 4 Use of extension cords and generators or transformers See section "Description / use of extension cords". en 7. Check that the insert tool has engaged correctly by pulling it. Disconnect the supply cord plug from the power outlet. Open the chuck by pulling back the insert tool locking sleeve. 7. 2 Operation CAUTION Always check to ensure that the selector switch is set to the correct function. CAUTION Use clamps or a vice to hold the workpiece securely. 7. 1 Preparing for use CAUTION Wear protective gloves when changing insert tools as the insert tools get hot during use. Adjust the depth gauge to the desired drilling depth. Tighten the screw at the depth gauge firmly. Disconnect the supply cord plug from the power outlet. Check that the connection end of the insert tool is clean and lightly greased. Check that the sealing lip of the dust shield is clean and in good condition. Clean the dust shield if necessary or have it replaced if the sealing lip is damaged. Push the insert tool into the chuck and rotate it while applying slight pressure until it engages in the guide grooves. Push the insert tool further into the chuck until it is heard to engage. 26 CAUTION Working on the material may cause it to splinter. Wear eye protection and protective gloves. [. . . ] The extension cord is too long or its gauge is inadequate. The control switch is not pressed fully. The "Reduced power" (50% power) button is engaged. The voltage provided by the electric supply is too low. [. . . ]