User manual HILTI TE7-C

[. . . ] TE 7-C Bedienungsanleitung Operating instructions de en 1 1 2 3 5 6 TE 7-C 4 7 2 1 3 4 3 3 2 TE 7-C 2 5 1 4 4 4 1 5 5 1 TE 7-C 3 6 2 6 1 7 1 2 2 3 3 4 8 9 TE 7C rotary hammer It is essential that the operating instructions are read before the power tool is operated for the first time. Always keep these operating instructions together with the power tool. Ensure that the operating instructions are with the power tool when it is given to other persons. Contents 1. Manufacturer's warranty - tools 12. [. . . ] CAUTION Check that the clamping band is engaged in the groove provided on the power tool. Secure the side handle by turning the grip clockwise. 6. 2 Use of extension cords and generators or transformers Please refer to the "Description" section. 6. 1 Fitting the side handle 2 CAUTION Remove the depth gauge from the side handle in order to avoid injury. Disconnect the supply cord plug from the power outlet. 7. Pivot the side handle into the desired position. Adjust the depth gauge to the desired drilling depth. Tighten the side handle securely by turning it clockwise. 7. 1. 2 Fitting the insert tool 4 CAUTION Wear protective gloves when changing the insert tool. Disconnect the supply cord plug from the power outlet. Check that the connection end of the insert tool is clean and lightly greased. Clean it and grease it if necessary. CAUTION In the event of the drill bit sticking, the power tool will pivot about its own axis. Always use the power tool with the side handle fitted and hold it securely with both hands so that the resulting opposing force causes the slip clutch to release in the event of the drill bit sticking. Use clamps or a vice to hold the workpiece securely. 7. 1 Preparing for use 7. 1. 1 Adjusting the depth gauge 3 1. Release the side handle clamping band by turning the handle counterclockwise. Check that the sealing lip of the dust shield is clean and in good condition. Clean the dust shield if necessary or replace it if the sealing lip is damaged. Push the insert tool into the chuck and rotate it while applying slight pressure until it engages in the guide grooves. Push the insert tool further into the chuck until it is heard to engage. Check that the insert tool has engaged correctly by pulling on it. 7. 1. 3 Removing the insert tool 5 CAUTION Wear protective gloves when changing insert tools as the insert tool may get hot during use. Disconnect the supply cord plug from the power outlet. [. . . ] The extension cord's conductor cross section is inadequate. The control switch is not pressed fully. The drill bit doesn't rotate. The function selector switch is not engaged or is in the "Chiseling" or "Chisel adjustment" position. The forward/reverse switch is set to reverse rotation. The drill bit can't be released. The drill bit makes no progress. 25 10. [. . . ]