User manual HILTI TE70-ATC

[. . . ] TE 70 / TE 70-ATC / TE 80-ATC Bedienungsanleitung Operating instructions Mode d'emploi Manual de instrucciones Istruzioni d'uso Gebruiksaanwijzing Brugsanvisning Bruksanvisning Bruksanvisning Käyttöohje Manual de instruções Lietoßanas pamåcîba Instrukcija Kasutusjuhend de en fr es it nl da no sv fi pt el lv lt et 1 2 3 6 4 5 4 5 3 2 6 7 8 TE 80ATC/ TE 70ATC/ TE 70 combi hammer It is essential that the operating instructions are read before the power tool is operated for the first time. Always keep these operating instructions together with the power tool. Ensure that the operating instructions are with the power tool when it is given to other persons. Contents 1. EC declaration of conformity Page 17 18 20 20 22 25 25 27 28 29 30 30 1 These numbers refer to the corresponding illustrations. [. . . ] Pivot the side handle into the desired position. CAUTION Check that the clamping band is engaged in the groove provided on the power tool. Secure the side handle by turning the grip clockwise. 6. 2 Use of extension cords and generators or transformers Please refer to section 2 "Description". 6. 1 Fitting and adjusting the side handle 2 1. Disconnect the supply cord plug from the power outlet. Release the side handle clamping band by turning the handle counterclockwise. en 7. Check that the sealing lip of the dust shield is clean and in good condition. Clean the dust shield if necessary or have it replaced if the sealing lip is damaged. Push the insert tool into the chuck and rotate it while applying slight pressure until it engages in the guide grooves. Push the insert tool further into the chuck until it is heard to engage. Check that the insert tool has engaged correctly by pulling it. Disconnect the supply cord plug from the power outlet. Open the chuck by pulling back the insert tool locking sleeve. 7. 2 Operation CAUTION In accordance with the applications for which it is designed, the power tool produces a high torque. Always use the side handle and hold the power tool with both hands. The user must be prepared for sudden sticking and stalling of the insert tool. CAUTION Use clamps or a vice to hold the workpiece securely. CAUTION The collar at the front end of the gearing section is not to be used as a gripping surface. 7. 1 Preparing for use CAUTION Wear protective gloves when changing insert tools as the insert tools get hot during use. Disconnect the supply cord plug from the power outlet. Check that the connection end of the insert tool is clean and lightly greased. Clean it and grease it if necessary. CAUTION Working on the material may cause it to splinter. [. . . ] The extension cord is too long or its gauge is inadequate. The control switch is not pressed fully. The "Reduced power" (50% power) button is engaged. The voltage provided by the electric supply is too low. [. . . ]