User manual HILTI WSC 267-E

[. . . ] EC declaration of conformity Operating controls and parts 1 @ Battery Page 17 18 20 20 21 25 26 29 30 30 31 32 ; Release buttons with additional function = Charge status and fault display (Li-ion battery) % Control switch & Switch-on interlock ( Auxiliary grip ) Drive spindle lockbutton + Hexagon socket wrench § Cutting angle scale / Clamping lever for cutting angle adjustment : Clamping screws for the parallel guide · Clamping lever for cutting depth adjustment $ 45°cutting line indicator £ 0°cutting line indicator | Parallel guide (rip fence) ¡ Pivoting guard Q Riving knife W Base plate E Guard R Rotatable chip ejector T Drive spindle Z Mounting flange U Clamping flange I Clamping screw O Cutting depth scale P Riving knife fastening screws Ü Pivoting guard operating lever [ Chip deflector guard ] Chip deflector guard release Æ Angle extender for 50° cuts (charge status display activation) en 1. General information 1. 1 Safety notices and their meaning DANGER Draws attention to imminent danger that could lead to serious bodily injury or fatality. WARNING Draws attention to a potentially dangerous situation that could lead to serious personal injury or fatality. CAUTION Draws attention to a potentially dangerous situation that could lead to slight personal injury or damage to the equipment or other property. [. . . ] m)The kerf must be free of obstructions. n) Never press the drive spindle lockbutton while the saw blade is rotating. o) Never direct the power tool toward persons. p) Adjust the pressure applied to the saw blade and the material being cut so that the blade doesn't 24 stall, possibly causing the power tool to kick back. 5. 2. 6 Power tool use and care a) Secure the workpiece. Use clamps or a vice to secure the workpiece. The workpiece is thus held more securely than by hand and both hands remain free to operate the power tool. b) Check that the insert tools used are compatible with the chuck system and that they are secured in the chuck correctly. 5. 2. 7 Electrical safety jury through contact with caustic substances may otherwise result. d) Do not use batteries other than those approved for use with the applicable power tool or appliance. Use of other batteries or use of the battery for purposes for which it is not intended presents a risk of fire and explosion. Charging progress is indicated by the LEDs (see section "Charge status of Li ion batteries"). 6. 3 Fitting the battery CAUTION Use only Hilti B 36/2. 4 NiCd or B36/3. 3 Li-ion batteries for the WSC 70 A36, and B 24/2. 0 NiCd batteries for the WSC 55 A24. CAUTION Check that the power tool is switched off and the switch interlock activated before fitting the battery. Use only the Hilti batteries approved for use with this power tool. Push the battery into the power tool from the rear as far as it will go and until it is heard to engage with a double click. CAUTION A falling battery may present a risk of injury to yourself or others. Check that the battery is seated securely in the power tool. Pull the battery out of the power tool toward the rear. en CAUTION Use only the Hilti chargers listed under "Accessories". DANGER Ensure that the outer surfaces of the battery are clean and dry before inserting it in the corresponding charger. Read the operating instructions for the charger for further information about the charging procedure. 6. 2. 1 Charging a new battery for the first time A new battery must be charged correctly for the first time before use. [. . . ] (Please refer to the operating instructions for the charger. ) Press the switch-on interlock and the control switch again. The retaining lugs on the battery are dirty. Clean the retaining lugs and check that the battery engages securely. Contact Hilti Service if the problem persists. Switch the power tool off immediately, remove the battery and contact Hilti Service. [. . . ]