User manual HILTI WSR 1200-PE

[. . . ] WSR 1200-PE D GB F I S Bedienungsanleitung Operating instructions Mode d'emploi Istruzioni d'uso Brugsanvisning 1­ 7 9­15 17­23 25­31 33­38 325934 *325934* 1 ¹ ¸ µ ¾ ¶ ² 2 3 min. 40mm 4 min. 40mm 5 6 7 8 9 max. 25mm 10 11 12 WSR 1200-PE reciprocating saw General information It is essential that the operating instructions are read before the tool is operated for the first time. Always keep these operating instructions together with the tool. Ensure that the operating instructions are with the tool when it is given to other persons. In these operating instructions, this symbol indicates points of particular importance to safety. [. . . ] A guard or other part that is damaged should be properly repaired or replaced by an authorized service centre unless otherwise indicated in this instruction manual. Have defective switches replaced by an authorized service facility. Do not use the tool if the switch does not turn it on and off. Ensure that the insert tools (saw blades etc. ) are equipped with the appropriate connection end to fit the blade holder on the electric tool and that they are clamped in position correctly in the blade holder. Use only the recommended original Hilti accessories and auxiliary equipment. Failure to observe this point may result in damage to the tool or present a risk of accident. Accordingly, if necessary, have the tool repaired at a Hilti service centre or authorised Hilti repair workshop. Always wear protective gloves and suitable protective goggles when working as saw blades may break or splinter. It is safer than using your hand and it frees both hands to operate the tool. Form the habit of checking to see that keys and adjusting wrenches are removed from the tool before switching it on. Always ensure that the blade clamping mechanism is kept clean. c) Turn the blade clamp locking sleeve in a counterclockwise direction. Insert the blade in the blade clamp and press in the locking sleeve. Release the locking sleeve until it is heard to engage. Check that it is held securely by pulling on the blade . Note: If the saw blade cannot be inserted into the blade clamp, turn the locking sleeve a little until the blade is in the correct clamping position and then release the locking sleeve. Removing the insert tool a) Unplug the supply cord from the electrical socket to prevent unintentional starting. b) Turn the locking sleeve and pull out the blade . The insert tool may be very hot after long periods of use. Preparation for use It is essential that the safety precautions printed in these operating instructions are read and observed. The supply voltage must correspond to the information on the type plate. If extension cords are used: Only extension cords of a type approved for the intended use and of adequate cross section may be used. Failure to observe this point may result in reduced performance of the tool and overheating of the cord. Damaged extension cords must be replaced. length for extension cords are: Mains voltage 100 V 230 V Conductor cross-section 1. 5 mm2 2. 5 mm2 20 m 40 m 50 m 100 m Sawing Setting the stroke rate The recommended stroke rate can be pre-selected by turning the stroke rate adjusting wheel to the desired setting. [. . . ] 13 Warranty Hilti warrants that the tool supplied is free of defects in material and workmanship. This warranty is valid so long as the tool is operated and handled correctly, cleaned and serviced properly and in accordance with the Hilti Operating Instructions, all warranty claims are made within 12 months from the date of the sale (invoice date), and the technical system is maintained. This means that only original Hilti consumables, components and spare parts may be used in the tool. This warranty provides the free-of-charge repair or replacement of defective parts only. [. . . ]