User manual HITACHI POWER TOOLS CB13F

[. . . ] Model CB 13F Band Saw INSTRUCTION MANUAL AND SAFETY INSTRUCTIONS WARNING Improper and unsafe use of this power tool can result in death or serious bodily injury!This manual contains important information about product safety. Please read and understand this manual before operating the power tool. Please keep this manual available for others before they use the power tool. TABLE OF CONTENTS SECTION Page Products Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Lock the lock knobs (12) under the table. Adjust the blade tracking and tension properly (See ADJUSTMENT INSTRUCTIONS section) before operation the band saw. Fig. G 1 WARNING To avoid injury, the blade tension, tracking, and upper and lower guides and bearings must be properly adjusted before operating the band saw. (See ADJUSTMENT INSTRUCTIONS section) 10 6 5 8 9 4 7 2 11 MITER GAUGE (Fig. H) A miter gauge (1) is supplied with your band saw to be used in the table slot (2) on the right side of the blade. The miter gauge can be tilted 0 to 45 deg. right or left to maintain an accurate angle for your workpiece. A bracket is provided on the leg stand for convenient miter gauge storage. Fig. H 1 3 8 10 2 13 12 WARNING Before operation always make sure the blade is in center of table insert slot. -- 13 -- INSTALL POWER BCORD BRACKETS (Fig. Power cord brackets (1) are provided for convenient cord storage. Attach the power cord brackets to the back of the saw body, as shown, with two Phillips head screws (2). Wrap the power cord onto the brackets when the band saw is not in use, to prevent damage to the cord. Fig. I 2 ADJUSTING THE 90° TABLE STOP (Fig. Loosen the table lock knobs (2) and tilt the table to the right. Loosen the nut (4) on the table stop bolt (5) and lower the stop bolt as far as possible. Tilt the table until rests on the stop bolt. Place a combination square (6) on the table with the heel of the square against the saw blade 5. Adjust the tilt of the table left or right until it is 90° to the blade. Male sure there is no space between the square and the blade. Adjust the table stop bolt up until it touches the table. Loosen the lock knobs and see that the table is resting on the stop bolt. Check the square to make sure the table is still square to the blade. [. . . ] Reduce load to motor, feed work slower into blade. Reduce load to motor, feed work slower into blade. Too many electrical appliances on same circuit. Have electrician upgrade service to outlet. Frequent blowing of fuses or breaking of circuit -- 22 -- PARTS LIST 12" BAND SAW Always order by I. D. [. . . ]