User manual HITACHI 46UX50B

[. . . ] 10 REMOTE CONTROL BATTERY INSTALLATION AND REPLACEMENT . . . . . . . 10 HOW TO SET UP YOUR NEW HITACHI PROJECTION TV. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 HOOK-UP CABLES AND CONNECTORS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 ANTENNA CONNECTIONS TO REAR JACK PANEL. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Release both buttons when the VCR starts to change channels. The Genius Remote will now control your VCR. Click here to see the CLU-850GR in the VCR position. If your VCR cannot be operated after performing the above procedures, this means that your VCR's codes have not been precoded into the GENIUS REMOTE. Please store your VCR codes in memory by using the USER mode. The GENIUS REMOTE CONTROL will remember the codes you have programmed in until the batteries are removed from the GENIUS REMOTE CONTROL. After replacing the batteries repeat the entire programming procedure stated above. If you have a play back only VCR (no CH UP/DOWN function), please follow operating step 5 described above and then check a VCR function until you find the button that will allow the precoded VCR buttons to operate your VCR. PRECODED VCR BUTTONS These buttons always transmit the chosen precoded VCR codes. SELECT BUTTON This is for setting up the Genius Remote to transmit the VCR's remote codes. EXCLUSIVE TV BUTTONS These buttons are for operating the TV. 29 USING THE REMOTE TO CONTROL CABLE BOX FUNCTIONS USING THE REMOTE TO CONTROL CABLE BOX FUNCTIONS Operating the pre-coded function for your Cable Box This Genius Remote is designed to operate different types of cable boxes. Before starting the memory operation Since the infrared signals sent from the remote transmitter may be reflected by a wall, door, etc. , even if the transmitter is not pointed directly at the device, it may operate. When storing the remote control codes of another device, turn OFF the power of the device (VCR, Cable Converter, etc. ) If you do not do this, the device may work unexpectedly. The power could be turned ON, an important tape could be erased, the volume could increase too much, etc. . Click to see CLU-850GR in the USER position LEARNABLE BUTTONS These buttons can "learn" the codes of other remote control transmitters when the MULTI-PAGE select switch is set to the "USER" mode. MULTI-PAGE keys (A through L): No codes have been factory stored to these keys. Learning buttons other than MULTI-PAGE buttons: the codes for the TV have been stored in memory. However, the remote control codes of other equipment (cable converter, audio equipment, etc. ) can be stored using the learning function as shown on page 27, 28. EXCLUSIVE BUTTONS These buttons are for operating the TV. Storing Operation Set the remote transmitter as shown below. Put the remote transmitter which contains the codes to be stored and the GENIUS REMOTE transmitter to face each other. (Distance should be 2 4 inches. ) Set the LEARN/USE mode select switch located on the back of the Genius Remote to the LEARN position. [. . . ] Antennas, cabinet, cabinet parts, knobs, batteries and accessories. Screens that have been cleaned with anything other than water and a mild soap solution. Lenses from units that have been sold or transferred from the original purchaser. Any lens element that is permanently attached to the CRT assembly is excluded from the lifetime warranty. [. . . ]