User manual HITACHI 46UX51K

[. . . ] NOTE: · There are no user serviceable parts inside the television. · Model and serial numbers are indicated on back side of the television. · This television is not intended for use in a computer room. CAUTION: Adjust only those controls that are covered in the instructions, as improper changes or modifications not expressly approved by Hitachi could void the user's warranty. MODIFICATIONS: The FCC requires the user to be notified that any changes or modifications made to this device that are not expressly approved by Hitachi America, Ltd. [. . . ] The SWAP function will not operate if ANT B input is set as the main channel (ANT B input cannot be displayed as a sub-picture. (3) MOVE Button To move the sub-picture to another corner, press the MOVE button. The sub-picture moves one step counterclockwise every time the MOVE button is pressed. (Example below illustrates the MOVE operation for initial shipping conditions. If you have customized a PIP position, the MOVE operation may differ slightly from this example). It is also possible to customize the PIP position. To do htis, wati until the On-Screen Display disappears (about eight seconds) and then use the CURSOR , , , buttons. 32 PICTURE-IN-PICTURE (PIP) (4) FREEZE (FRZ) button (With PIP ON) If you wish to freeze the Sub-Picture, press the FRZ button. This is convenient when trying to write down the address for a mail order company, recording statistics for a sporting event, etc. To return the picture to motion, press the FRZ button again. NOTE: The FREEZE function will only operate when SINGLE PIP mode is chosen. (5) FREEZE (FRZ) Button With PIP OFF Press the FRZ button to freeze one or four frames of the picture, depending on the mode previously selected (SINGLE or STROBE). The remote control will remember the codes you have programmed until the batteries are removed from the remote control. After replacing the batteries repeat the entire programming procedure as stated above. If your VCR does not have a power function, the remote will issue the CHANNEL UP function. The MENU button will act as the VCR MENU button for HITACHI VCRs. The LST-CH button will act as your VCR ENTER button if required. The SLEEP button will act as your VCR '100' button if required. 34 USING THE REMOTE TO CONTROL CABLE (1) VCR Button This button allows the remote to control your VCR by setting it to VCR mode. (2) PRECODED VCR Buttons These buttons transmit the chosen precoded VCR codes. For some VCRs, you must press the RECORD button twice to record a program. (3) EXCLUSIVE TV Buttons These buttons are for operating the TV. NOTE: Refer to instruction manual of the VCR for operation of the buttons exclusively for the VCR. USING THE REMOTE TO CONTROL CABLE BOX/SATELLITE FUNCTIONS Operating the precoded function for your cable box. This remote is designed to operate different types of cable boxes. You must first program the remote system cable box. [. . . ] Excessive heat or moisture may cause the unit to cease operation. When the batteries run down, remote control operation will become erratic or possibly stop altogether. Replace the old batteries with two new "AA" size batteries. Exposure of the viewing screen to prolonged direct sunlight or heat may cause the screen to permanently warp, resulting in a distorted picture. 67 RECEPTION PROBLEMS RECEPTION PROBLEMS · IGNITION NOISE: Black spots or horizontal streaks may appear, picture may flutter or drift. [. . . ]