User manual HITACHI 60UX55K

[. . . ] Home Electronics Division may void the user's authority to operate the equipment. POWER SOURCE This projection television is designed to operate on 120 volts 60Hz, AC current. Insert power cord into a 120 volt 60Hz outlet. TO PREVENT ELECTRIC SHOCK, DO NOT USE THE TELEVISION'S (POLARIZED) PLUG WITH AN EXTENSION CORD, RECEPTACLE, OR OTHER OUTLET UNLESS THE BLADES AND GROUND TERMINAL CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE. NEVER CONNECT THE TELEVISION TO 50HZ, DIRECT CURRENT, OR ANYTHING OTHER THAN THE SPECIFIED VOLTAGE. NOTE: This television receiver will display television closed captioning, ( paragraph 15. 119 of the FCC rules. CC or ), in accordance with CAUTION: Never remove the back cover of the television as this can expose you to very high voltages and other hazards. [. . . ] Box 55512 Any Town, USA 98765 Check or Money Order Only 1-800-555-1212 FRZ SINGLE STROBE Hot Springs Clay Mask C/O MILES Run-Spa Retreat P. O. Box 55512 Any Town, USA 98765 Check or Money Order Only 1-800-555-1212 FRZ STROBE FREEZE Press the FRZ button to freeze four frames of the picture you are currently viewing. Press this button again or PIP to return to normal viewing. This feature is useful for viewing a moving picture that has many details, for example, a close play in a sporting event or golf swing. Hot Springs Clay Mask C/O MILES Run-Spa Retreat P. O. Box 55512 Any Town, USA 98765 Check or Money Order Only 1-800-555-1212 Check or Money Order Only 1-800-555-1212 Hot Springs Clay Mask C/O MILES Run-Spa Retreat P. O. Box 55512 Any Town, USA 98765 Check or Money Order Only 1-800-555-1212 C/O MILES Run-Spa Retreat P. O. Box 55512 Any Town, USA 98765 Check or Money Order Only 1-800-555-1212 P. O. Box 55512 Any Town, USA 98765 Check or Money Order Only 1-800-555-1212 Any Town, USA 98765 Check or Money Order Only 1-800-555-1212 FRZ SINGLE STROBE FRZ CAUTION: A pattern burn may develop if the sub-picture is left in the same corner permanently. If the PIP feature is used frequently, occasionally MOVE the sub-picture to a different corner. You may also vary its position using the CURSOR , , , or buttons. NOTE: 1. Only sound from the main picture can be heard, unless you choose sub-picture audio from THEATER-WIRELESS SOUND mode and use the WIRELESS OUT outputs on the rear panel. EXCLUSIVE TV buttons These buttons are for operating the TV. 2 5 8 0 3 6 9 SLEEP 4 7 INPUT CLU-615MP 27 USING THE REMOTE TO CONTROL CABLE BOX/SATELLITE FUNCTIONS Operating the precoded function for your cable/satellite box. This remote is designed to operate different types of cable boxes and satellite systems. You must first program the remote to match the remote system of your cable/satellite box. Set the MULTI-PAGE select switch to TV/CABLE/SAT. Press the CABLE button on the remote to switch to CABLE mode, or the SAT button to switch to SAT mode. Aim the remote control at the front of your cable/satellite box. Hold down the CABLE/SAT button on the remote, enter the two digit preset code that matches your cable/satellite box as shown on page 30. The remote will turn off your cable/satellite box when the correct two digit preset code is entered. When this occurs, the remote control is programmed for your cable/satellite box. If the cable/satellite box does not turn off after five seconds, try another two digit preset code. The remote will now control your cable/satellite box. 6. , POWER TV CABLE SAT NOTES: 1. [. . . ] Physical damage to the precision parts may result. Avoid placing the remote control in a high humidity place or getting it wet. Excessive heat or moisture may cause the unit to cease operation. When the batteries run down, remote control operation will become erratic or possibly stop altogether. Replace the old batteries with two new "AA" size batteries. Exposure of the viewing screen to prolonged direct sunlight or heat may cause the screen to permanently warp, resulting in a distorted picture. 59 RECEPTION PROBLEMS · IGNITION NOISE: Black spots or horizontal streaks may appear, picture may flutter or drift. Usually caused by interference from automobile ignition systems, neon lamps, electrical drills, and other electrical appliances. · GHOSTS: Ghosts are caused by the television signal following two paths. [. . . ]