User manual HITACHI AXF100WUN

[. . . ] To clean the cabinets and panels when dirty, clean off dirt on the surfaces with a soft, dry cloth. Never use thinner, benzene or alcohol, as these will damage the surface finish. Protect the unit against excessive heat (e. Discs which can be played on the CD player have the following mark on them: · Be careful not to damage the power supply cord. [. . . ] (The remote control unit will operate at an angle of up to 30° in either direction. If good reception cannot be achieved with the included FM antenna, use an FM outdoor antenna. Fäst en anslutning av F-typ till koaxialkabeln och anslut sedan antennen till terminalen FM COAX (75 /ohm). Check that the following parts are included in the package: · Tape control buttons and CD EDIT button are for HITACHI model D-R100E only. MD control buttons are for HITACHI model HMD-R50E only. This unit can be set to ecology mode for power saving in standby mode. To set to STANDBY mode when the unit is in ECO-ON mode. NOTE: ECOLOGY mode cannot function when TIMER is ON. To set to STANDBY mode when the unit is in ECO-OFF mode. Repeat steps 1 ­ 6 to preset other stations. After step 5, station name can be entered (see page 61). Repeat current track · This is only operational in combination with the D-R100. Use this function to automatically edit the CD tracks according to the preset length (time) of the cassette tape. NOTE: To set a time other than the preset, input the time when "C---" is displayed. Load the cassette tape onto which you want to record in the tape deck, with side A on the top before starting the editing procedure. Note that even if the tape is slightly longer than the disc's total playing time, it may not be possible to record all the tracks on sides A and B. If you wish to record all the tracks, use manual recording or CD SRS Recording. Blank segments of 5 seconds are automatically created between the recorded tracks so the displayed time and the actual remaining time on the tape slightly differ. After step 5 on page 46, follow the steps below. To receive the next RDS station, repeat steps 2 and 3. Note: If a station does not have RDS, the PANEL mode cannot be changed. To receive the next PTY station, repeat steps 2 ~ 4. [. . . ] Signals on the power cord are being modulated by the power source frequency. Humming sound is heard when disc is played. The HCU-R30E is equipped with a high speed protector circuit. This circuit protects internal parts from being damaged by strong currents generated in the unit should the unit be operated when the speaker terminals are incompletely connected or short circuited. [. . . ]