User manual HITACHI AXM75DAB

[. . . ] MINI HIFI AUDIO SYSTEM WITH DAB TUNER RECEIVER SYSTEM AXM75DAB Instruction Manual Before operating please read all these instructions thoroughly. SOME DOS AND DON'TS ON THE SAFE USE OF EQUIPMENT This equipment has been designed and manufactured to meet international safety standards but, like any electrical equipment, care must be taken if you are to obtain the best results and safety is to be assured. ************** DO read the operating instructions before you attempt to use the equipment. DO ensure that all electrical connections (including the mains plug, extension leads and interconnections between the pieces of equipment) are properly made and in accordance with the manufacturer's instructions. Switch off and withdraw the mains plug before making or changing connections. [. . . ] Check your aerial is fully extended. 16 AMPLIFIER AND TUNER Changing the display mode The unit has six display modes which enable you to view parts of the broadcast data on the bottom line of the display. Press the "DISPLAY" button 42 and repeat to cycle through the six different display modes. Scrolling text The default mode, displays scrolling text messages which accompany the audio, where available. A label describing the type of content being broadcast by the service. Displays the name of the mulitiplex in which the current service is found, see "Guide to Digital Radio" on pagg 21 for more information on multiplexes. Displays the date and time obtained from the current mulitiplex. Displays the mode of the channel identifier and frequency for the station to which you are tuned, see "Guide to Digital Radio" on page 21 for more information. Displays the mode of the current service, Stereo or Mono and the data rate at which the aduio signal is being transmitted. This rate is set by the broadcaster to suit the type and quality of material being transmitted. Displays the signal error rate for the signal to which you are tuned. As a guide values from 0 to 15 indicate good reception, 16 to 30 borderline reception and 31 or more, poor reception. You can attempt to reduce this signal error rate by adjusting your aerial position using Manual tune option described on page 18. Program Type Multiplex name Date and time Channel Mode Signal error 17 AMPLIFIER AND TUNER Storing and recalling presets The numeric buttons (1-9) enable you to store radio stations for one-touch access. To store a station You can store a station to a preset while listening to it or when you see the station name on the bottom line of the display while scrolling through the station list. Press and hold down a numbered button for around two seconds to store the station under that number. "Preset 1 saved" when the station has been successfully saved. Once you save a station to a preset, the station name has the preset number next to it on the station list. To recall a previously stored station Press the numeric button 3 under which you stored the station. If the selected preset is empty, the display shows "No Station Available". Please select another preset and make sure the preset has station stored. Manual tune This option provides a signal level display which you can use to find the best position for your radio and aerial. When you select this option, the bottom line of the display shows the channel identifier and frequency. Press "MENU" button 5 or 43, rotate "MULTI FUNCTION" knob 8 to "Manual tune" and press "SELECT" knob 17 or 41. [. . . ] Press "CLOCK" key 15 or 36 twice will activate the timer mode. Press "SELECT/ALARM ON OFF" 17 or 41, the hour digit of alarm on will blink, turn the "MULTI FUNCTION" knob 8 to set the hour. Press "SELECT/ALARM ON OFF" 17 or 41 again, the minute digit will blink, turn the "MULTI FUNCTION" knob 8 again to set the minute. Press "SELECT/ALARM ON OFF" 17 or 41 to confirm. [. . . ]