User manual HITACHI C 13U

[. . . ] Let only the authorized service center do the repairing. The manufacturer will not be responsible for any damages or injuries caused by repair by unauthorized persons or by mishandling of the tool. To ensure the designed operational integrity of power tools, do not remove installed covers or screws. Do not touch movable parts or accessories unless the power source has been disconnected. [. . . ] Ensure that the material is free of foreign matter such as nails. The riving knife should always be used except when plunging in the middle of the work piece. The saw blades should be from 305 mm to 335 mm external diameter ranges. * Be sure to check the nameplate on product as it is subject to change by areas. 1 Standard accessories are subject to change without notice. When the base and saw blade are at a perpendicular angle, use the link scale to adjust the cutting depth. Measure the distance that the saw blade extends to adjust the cutting depth to the correct distance because the scale marks are only indicated for reference. Lift the base until the depth of cut on the main unit reaches the minimum state, fasten the clamp lever, and secure the base. 2) (2) Install the riving knife to the arm securely with the 2 attached bolts. Adjusting the riving knife Loosen the hexagon head bolts used to clamp the riving knife, adjust the riving knife to the position shown in Fig. After adjustment, ensure that the riving knife moves by following the adjusted cutting depth. 2) on the rear of the base, the saw blade may be inclined to a maximum angle of 45° in relation to the base. Always ensure that the wing bolts are securely tightened after making the desired adjustment. 6) The cutting position can be adjusted by moving the guide to the left or right after loosening its wing bolt. The guide can be mounted on either the right or left side of the base. Dust collection adapter Connect the suction hose to collect saw dust with the vacuum cleaner (see Fig. Optional accessory is subject to change without notice. Power source Ensure that the power source to be utilized conforms to the power requirements specified on the product nameplate. Power switch Ensure that the power switch is in the OFF position. If the plug is connected to a power receptacle while the power switch is in the ON position, the power tool will start operating immediately, which could cause a serious accident. Extension cord When the work area is removed from the power source, use an extension cord of sufficient thickness and rated capacity. The extension cord should be kept as short as practicable. [. . . ] CAUTION On completion of mounting the saw blade, reconfirm that the lock lever is firmly resumed in the original position. Information concerning airborne noise and vibration The measured values were determined according to EN50144. the typical A-weighted sound pressure level: 91 dB (A). The typical A-weighted sound power level: 104 dB (A) Wear ear protection. [. . . ]