User manual HITACHI CJ110MVA

[. . . ] Read through carefully and understand these instructions before use. English 1 2 3 4 5 6 7 8 9 0 A B C D E F G H I J K L M N O P Lever Blade Blade holder Roller Dial Change knob Splinter guard Base Chip cover Base bolt Hexagonal bar wrench Guide Attachment hole M5 bolt Nail or screw Guide hole Scale Semi-circular part -mark Cleaner Dust collector Adapter Nose Rear hole Hook Notch Hebel Blatt A wrench or a key left attached to a rotating part of the power tool may result in personal injury. This enables better control of the power tool in unexpected situations. Do not wear loose clothing or jewellery. [. . . ] Ensure the switch is in the off position before plugging in. Carrying power tools with your finger on the switch or plugging in power tools that have the switch on invites accidents. D) Remove any adjusting key or wrench before turning the power tool on. This Jig saw employs a high-power motor. If the machine is used continuously at low speed, an extra load is applied to the motor which can result in motor seizure. Always operate the power tool so that the blade is not caught by the material during operation. Always adjust the blade speed to enable smooth cutting. *Be sure to check the nameplate on product as it is subject to change by areas. 1 Standard accessories are subject to change without notice. (2) Guide (3) Sub base (4) Bench stand (Model TR12-B) Optional accessories are subject to change without notice. Switch is in the ON position, the power tool will start operating immediately, which could cause a serious accident. Extension cord When the work area is removed from the power source, use an extension cord of sufficient thickness and rated capacity. The extension cord should be kept as short as practicable. A) Wear a dust mask b) Use external dust collection equipment When using the external dust collection equipment, connect the adapter with the hose from external dust collection equipment. 1-III) CAUTION: Be sure to switch power OFF and disconnect the plug from the receptacle when changing blades. Do not open the lever when plunger is moving. Adjusting the blade operating speed This Jig Saw is equipped with the electric control circuit which enables stepless speed control. To adjust the speed, turn the dial shown in Fig. When the dial is set to "1", the jig saw operates at the minimum speed (850min­1). When the dial set to "5", the jig saw Cutting various lumber and pocket cutting Cutting mild steel plate, aluminum plate, and copper plate Cutting synthetic resins, such as phenol resin and vinyl chloride Cutting thin and soft construction materials Cutting stainless steel plate (with No. Power source Ensure that the power source to be utilized conforms to the power requirements specified on the product nameplate. Power switch Ensure that the power switch is in the OFF position. [. . . ] 13) (2) In other materials When cutting a window hole in materials other than lumber, initially bore a hole with a drill or similar tool from which to start cutting. Angular cutting The base can be swiveled to both sides by up to 45° for angular cutting. NOTE: Angular cutting can not be done when adopting chip cover or dust collector. CAUTION: In order to prevent blade dislodging, damage or excessive wear on the Plunger, please make sure to have surface of the base plate attached to the work piece while sawing. [. . . ]