User manual HITACHI CMPAK345

[. . . ] Hitachi Plasma Screen Tilting Wall-mount Unit Model CMPAK345 Installation Instructions Thank you for purchasing the Hitachi Plasma Screen Wall-mount Unit. To ensure correct usage, please read this instruction manual thoroughly. After reading, please store this manual in a safe place for future reference. [. . . ] · Security bolt ­ Prevents removal of screen after installation. FAX: 01283 792300 List of Components INSTALLATION Installation of this unit should be carried out by qualified technicians. Install in an appropriate location only after checking wall structure and durability for accident prevention. Consult a qualified builder if in any doubt of wall structural integrity. 1. MOUTING WALL PLATE Mount the wall plate on the wall using screws and/or bolts appropriate to wall construction (if in doubt consult a qualified builder). Locate screws and/or bolts through all 8 holes (Fig. ATTACHING SUSPENSION PLATE TO PLASMA DISPLAY Attach the suspension plate (Fig. 2) to rear of the Plasma screen using screws/washers/isolators appropriate to model of the Plasma screen. 2A for location holes relating to make and model of the Plasma Screen. Tighten screws with hex head key supplied. Determine the amount of screen tilt required (0 to 10 degrees) Adjust accordingly, loosening the angle adjustment socket screw (Fig. For a flat 0 degree installation, lock the tilt plate into position by fastening cheese-head screws to their maximum through locator holes on tilt plate. Tighten angle adjustment screws - both sides (Fig. ENGAGING PLASMA/SUSPENSION PLATE WITH WALL BRACKET Minimum two fit persons required Lift the Plasma display to engage (Fig. The suspension bar is highlighted on the wall bracket by an orange sticker. [. . . ] Registered Office: 97 Lichfield Street, Tamworth, Staffs B97 7QF Angle adjustment Socket Screw WALL PLATE Tilt Plate Suspension Bar (Orange Sticker) M5 Cheesehead Screws Wall Plate Strap FIG 1 FIG 2A B B A A A A B Hole Screen A B Hitachi 37/42 Hitachi 50 Fixing B 4 off, M6 x 20mm + washers 4 off, M8 x 20mm + washers FIG 2 Suspension Hooks Suspension Plate Steel Washer x4 Nylon Insulating Washer x4 Security Bolt Nylon Insulating Spacer Plug x4 (Panasonic & Toshiba screens) FIG 3 Hook onto bar on wallplate FIG 4 3 cm Angle adjustment screw 3 cm movement side to side Fastening bolt Fine adjust angle using Angle adjustment screw. Secure screen using fastening bolt on backplate A Angle adjustment screw FIG 5 Wall 11~20 cm A Access cable by pulling display away from wall at base of screen Hitachi, Ltd. Tokyo Japan Digital Media Division 292 Yohida-cho, Totsuka-ku, Yokohama, 244-0817 Japan (045) 866-6302 [. . . ]